Last Activity:12-19-2013 9:39 PM
Posted in thread: More Boil Control? on 11-20-2013 at 02:16 AM
It is absolutely amazing what this little PID can do, it almost does too much. Thanks again!
Posted in thread: Simple SSVR-controlled e-BIAB rig on 11-20-2013 at 01:05 AM
Awesome job Pogden! I just moved away from my SSVR BIAB setup to a PID to maintain mash temps.
As of now I still like the way the SSVR maintains a boil.I ordered that same volt/ammeter about
Posted in thread: More Boil Control? on 11-20-2013 at 12:52 AM
Ok 3 Irish Reds later and here is what I can make of the issue after reading that thread. I did
auto tune, but only filled with about 5 gals and did not have my recirculating pump on. That
Posted in thread: More Boil Control? on 11-19-2013 at 11:52 PM
From what I am reading the "pulsing" should even out as temps stabilize but that was not the
case with a 90 min boil. I am running a keggle wrapped with thermal wrap to maintain mash
temps. You can't ...
Posted in thread: More Boil Control? on 11-19-2013 at 10:46 PM
Hey Jeff,When set at 70% in manual mode the element would heat the wort to a heavy boil for
approximately 3 seconds then go to a slow boil for approximately 3 seconds then repeat.Do you
know what para...
Posted in thread: More Boil Control? on 11-19-2013 at 02:06 AM
Just finished my EBIAB Setup and it works great. Thank you to PJ for the great schematics! The
Auber 2352 does an amazing job maintaining mash temp, but I am not thrilled with the quick ramp
up and do...
Posted in thread: what are you using to split circuits? on 11-15-2013 at 05:13 PM
Here is what I used. Said to handle well over 30 amps.
Posted in thread: How many gallons of EdWort's Apfelwein have been made? on 02-10-2013 at 08:06 PM
+5 = 24,933
Posted in thread: dog farts on 04-30-2010 at 02:52 AM
I use 3944 for all my Wit's and Heff's. I have found that temps must remain very consistent to
avoid the "Rhino Farts." Any fluctuation even within a few degrees seems to produce give off
Posted in thread: ebay aquarium temp controller build on 03-29-2010 at 09:45 PM
I just wanted to thank Andrew and all you guys for posting replys on this thread. I just got
mine in the mail and can't wait to get this hooked up. The thing that suprised me was the size,