wasabifan

LATEST ACTIVITY

• Posted in thread: Immersion Wort Chiller Design on 10-09-2012 at 01:02 AM
  Why not just use a bunch of zip ties rather than soldering?Good idea. I had not thought of
  that. I may do that. I was probably looking for an excuse to solder, but the zip ties would
  probably work as ...

• Posted in thread: Immersion Wort Chiller Design on 10-09-2012 at 12:58 AM
  I just noticed the spider on the wall in the background. It isn't real, it is a Halloween
  decoration I put in the shot by mistake.

• Posted in thread: Immersion Wort Chiller Design on 10-09-2012 at 12:36 AM
  So here is my chiller so far. I haven't soldered the coils to the output tubing yet, and 20
  feet didn't go as far as I had thought it would. I also found some old copper in the barn I can
  use for stra...

• Posted in thread: Immersion Wort Chiller Design on 10-05-2012 at 11:27 AM
  That sounds nice acidrain. I am only coiling 20 feet for my first cooler, but I think I may use
  the small gap between all coils and solder the inlet and outlet tubs to the coil (as my
  strapping) to ma...

• Posted in thread: Immersion Wort Chiller Design on 10-05-2012 at 01:38 AM
  Thanks earwig! I may start working on my chiller tomorrow.If you are interested in
  understanding what I meant by "the gap", if you look at these chillers they seem to all have
  one or two tight coils a...

• Posted in thread: Immersion Wort Chiller Design on 10-05-2012 at 01:06 AM
  I have picked up some copper tubing to build a DIY immersion wort chiller. In looking at some
  plans and commercial products online, I noticed some run coils all the way up from the base,
  but other lea...