VIEW MY

walther

Gift Premium Subscription To walther

Join Date:

04-13-2008

Last Activity:

06-12-2016 1:23 PM

3 Likes on 2 Posts 

LATEST ACTIVITY

  • Posted in thread: My first white mould cheese on 05-23-2016 at 07:28 PM
    Thanks for the feedback,After about a week they dried on the surface, and the mold started
    showing. After two weeks they were covered nicely, and I put them in a fridge.Now after three
    weeks they look...

  • Posted in thread: My first white mould cheese on 05-10-2016 at 08:57 PM
    My cheeses have now been in the fridge three days.They are still very wet on the surface, and
    it does not feel like the optimal environment for the white mould ? Should they be dry, moist
    or wet now ?...

  • Posted in thread: How can I increase humidity in my cheese fridge? on 05-10-2016 at 08:47 PM
    A Humidifier? I am not sure if that would add too much?I'm sure it will. The one I linked to,
    and similar types, are not designed for continous. They would also contribute with a
    considerable amount o...

  • Posted in thread: How can I increase humidity in my cheese fridge? on 05-08-2016 at 08:54 AM
    Look for "ultrasonic mist" or "ultrasonic humidifier" on eBay.Maybe they would work. I have one
    like this I might give a try:

  • Posted in thread: My first white mould cheese on 05-08-2016 at 08:25 AM
    Hi,I just made my first white mould cheese yesterday, and was looking for a forum. So I was
    delighted to see my favourite beer forum had a cheese section :)I also have 3D printing as a
    hobby,...

  • Posted in thread: Separation Funnel on 12-30-2015 at 10:42 PM
    Thanks, I will check the book out.Cheers,

  • Posted in thread: My 3D Printable Stirplate on 12-30-2015 at 12:37 PM
    @Strassburg, I live in Denmark, so you may know someone with a printer closer by :) Otherwise,
    drop me a pm.

  • Posted in thread: My 3D Printable Stirplate on 12-29-2015 at 04:15 PM
    I'm using a MendelMax 1.5, with an E3D-V6 head:

  • Posted in thread: My 3D Printable Stirplate on 12-29-2015 at 03:41 PM
    Thanks,I just just used a small PC fan controller. There is a hole in the back where I can
    reach it with a screwdriver.

  • Posted in thread: My 3D Printable Stirplate on 12-29-2015 at 03:30 PM
    Here is my 3D printable stirplate: requires a fan, some magnets, and a 3D printer :)

0 COMMENTS
POST A COMMENT