Last Activity:05-17-2014 10:19 PM
Posted in thread: First time brewing question on 03-31-2011 at 04:33 AM
Actually, I stand corrected.
Posted in thread: kegging to early by mistake on 03-31-2011 at 04:19 AM
You could consider a re-pitch.
Posted in thread: First time brewing question on 03-31-2011 at 04:16 AM
7 days primary, 7 days secondary is a good general rule for most beers. Hydrometer readings
will verify it if you feel it's necessary. FWIW, I always use a secondary, but I've got a dozen
or so carboy...
Posted in thread: Reusing slurry from dry-hopped IPA. Bad idea? on 03-31-2011 at 04:11 AM
Did you dry hop in the primary or use a secondary? Sounds like you used the primary. Either
way, I'd make a good starter. I just made a 1qt starter from a 1.065 IPA and used it in a 1.093
and it's sti...
Posted in thread: A Question About Head... on 09-10-2010 at 02:32 PM
I'm using the same glasses for four different kegs so I don't think they're the issue as the
others are fine. This particular ESB has a great thick head as the others do when it's poured.
After a few ...
Posted in thread: A Question About Head... on 09-09-2010 at 03:59 AM
I'll check out the article. Thanks for the info.
Posted in thread: A Question About Head... on 09-07-2010 at 09:49 PM
What causes the foam to break up? I force carbonated the keg and it's been under about 11 psi
for two weeks. Great head after the pour starts breaking up about 10 minutes later. It's been
doing this s...
Posted in thread: At a loss... 1 keg foams, the others don't on 08-22-2010 at 02:23 PM
Yep. The poppet was stuck and the QD couldn't open it properly. The restricted opening changed
the flow of the beer. If you get real curious, look up Bernoulli's principle.
Posted in thread: At a loss... 1 keg foams, the others don't on 08-21-2010 at 07:46 PM
I could see that. Turns out it was my poppet so thanks to Brewfat. I disassemble and clean my
faucets every Sunday. I went a month once and it was nasty. Could be because my fridge is
outside in South...
Posted in thread: At a loss... 1 keg foams, the others don't on 08-21-2010 at 01:46 AM
Changed out the poppet. Seems to have improved a bit but still have some foam in the line. Keg
is a bit warm after the work so I'll let it cool back down and check again. If that doesn't
work I'll cha...