vballdrummer

Gift Premium Subscription To vballdrummer

Join Date:

05-29-2009

Last Activity:

10-01-2012 9:18 AM

    ABOUT ME

  • Springboro,OH
  • Male
  • Married

LATEST ACTIVITY

  • Posted in thread: Instant Hot Water on 11-11-2011 at 12:17 PM
    I've looked into this too, Depending on how hot you want the water, it gets pretty expensive
    for the unit. Home-use units are temp limited to about 140 degrees to prevent scalding (at
    least her in USA...

  • Posted in thread: BCS 462 & 6" Temp Probe (and maybe more) on 11-07-2011 at 01:56 PM
    Pm sent

  • Posted in thread: New eControlBox (based on Ohio-Ed's) on 06-15-2011 at 02:41 PM
    The software is "functional" to brew, but not at all complete - I've not been able to do
    anything on this in a couple of months due to being so busy. But I do brew on it. It was my
    Winter project, and...

  • Posted in thread: Which solder and flux? on 06-14-2011 at 01:12 AM
    eBay, it's not cheap, but a little goes a long way ... I still have lotz on my roll.Oh and the
    liquid flux can also be had at your local welding supply -- they will probably not carry the #8
    though

  • Posted in thread: Which solder and flux? on 06-14-2011 at 12:43 AM
    +1 Harris Stay-Brite solder and Harris Stay-Clean liquid fluxMake sure it is #8 solder -- this
    is a bearing-type solder with a higher silver content giving it the holding power you need for
    torque. Th...

  • Posted in thread: Skeeter Pee on 06-11-2011 at 08:00 PM
    Fermented out in six days :rockin:6/5 @1.0716/11 @0.0995Here's a vid of the fermentation
    activity on day two:[ame] time to finish up, back-sweeten, then keg and carb!

  • Posted in thread: Labjack brewing software on 06-02-2011 at 05:27 PM
    My LabJack based system is in use; it's not polished, it's not complete, but it does brew beer.
    I used LabView instead of DAQfactory because it's free for me to use

  • Posted in thread: March Pump 809 PL/HS-C - $125 FREE S/H on 05-24-2011 at 01:54 PM
    fair enough, but when someone only posts in the classifieds it makes one wonder -- 15 posts, 13
    of them to sell something with no contributions to any other forums. If Jay is selling off his
    stuff - n...

  • Posted in thread: March Pump 809 PL/HS-C - $125 FREE S/H on 05-24-2011 at 01:31 PM
    jxm2119 - Are you a registered vendor?

  • Posted in thread: Stout Tanks and Kettles - $400 14.5 Gal Conical on 05-17-2011 at 06:13 PM
    @jazong - my only concern was the longer the tube (moment arm) the more torque applied to the
    weld. When they arrived I (re)assured myself that the weld is solid enough to withstand weight
    and motion ...

Following Stats
0 COMMENTS
POST A COMMENT

Newest Threads

PHOTO OF THE DAY