uniconfis

LATEST ACTIVITY

• Posted in thread: Bison Brewing Company Honey Basil Ale Clone on 06-20-2012 at 04:41 PM
  I kegged this last night. I did add zest from two lemons in the secondary. This beer is
  awesome. Doesn't seem to need much for aging. I think it's ready to drink day one. I forced
  carbonated of course...

• Posted in thread: Bison Brewing Company Honey Basil Ale Clone on 06-06-2012 at 02:58 PM
  I just brewed this AG recipe last night. I think I'm going to add lemon zest to the secondary
  too. Seems like it would be a great summer brew.

• Posted in thread: Ebay Temperature Controller Problem on 01-25-2012 at 09:15 PM
  I think there is a way to calibrate these temp controllers. Maybe that is what needs to be
  done.

• Posted in thread: Heatstick be trippin' on 01-13-2012 at 02:50 PM
  Brewed a Black Butte porter last night using the new heat stick. Worked great. I don't know if
  I'll ever leave the kitchen for brewing now that dual heat sticks are working out. Well, at
  least for the...

• Posted in thread: Heatstick be trippin' on 01-12-2012 at 02:41 PM
  Tested the new heatstick today. Worked great! No leaks and GFI held the whole time. Thanks
  again guys!

• Posted in thread: Heatstick be trippin' on 01-10-2012 at 05:57 PM
  There is some small variation in the OD of the coupling, i had to test fit a few before i found
  one that fit. When it does fit, it's super tight. I had to tap the coupling in with a rubber
  mallet on o...

• Posted in thread: Heatstick be trippin' on 01-10-2012 at 04:19 AM
  Thanks Gritsak. I was looking at that earlier. Unfortunately I could not fit the 1" coupling in
  the chrome drain pipe. So I took the cardboard roll from paper towels and cut it to fit around
  the conne...

• Posted in thread: Heatstick be trippin' on 01-10-2012 at 12:53 AM
  Thanks for the feedback guys. I'm on my way to Home Depot. I'm going to follow your advice
  djt17. I'm sure we have the same issue. That looks like a solid solution.

• Posted in thread: Heatstick be trippin' on 01-09-2012 at 02:46 PM
  I recently built a second heat stick using these instructions. I probably used 2 tsp acetone to
  thin out the jb weld to pour into the chrome drain pipe to seal off the electrical connections.
  After ab...

• Posted in thread: Great Lakes Christmas Ale Clone on 12-09-2011 at 02:37 AM
  I'm at 1.018, but not rally getting any cinn or ginger flavor...I followed the recipe to a
  T....would you add a stick to the primary here and/or some ginger? would I have to boil first?
  thxBeernewb, t...