VIEW MY

twalsh

Gift Premium Subscription To twalsh

Join Date:

02-10-2013

Last Activity:

06-23-2013 11:24 AM

Likes Given: 1

1 Likes on 1 Posts 

    ABOUT ME

  • Beer Making and Welding
  • Engineer
  • Male
  • In a Relationship
  • California City
  • CA

LATEST ACTIVITY

  • Posted in thread: Unveiling my brewery & garage build on 05-26-2013 at 11:49 PM
    Great job. Are you going to move to a BCS system at some point?

  • Posted in thread: Single Tier, 3 Pump, BCS-462, Automated Rig on 05-17-2013 at 03:54 AM
    Thanks. In the youtube video you have (page 7) it looked like there was a false bottom in the
    HLT, which seemed a bit excessive, but also made me wonder if you were using them in all 3.
    Thanks again.

  • Posted in thread: Single Tier, 3 Pump, BCS-462, Automated Rig on 05-16-2013 at 06:57 AM
    Do you use false bottoms in all three of your brew pots?

  • Posted in thread: electronic valves on 04-07-2013 at 01:49 AM
    Thanks. It saves money but I wanted to at least get a little feedback before ordering.I tried
    the valve today and it works. So, that should give you a little more confidence.

  • Posted in thread: 12V relay board BCS 462 on 04-07-2013 at 01:21 AM
    Updated drawing that actually works. Thank you tphjr!

  • Posted in thread: 12V relay board BCS 462 on 04-07-2013 at 01:13 AM
    You are my hero!

  • Posted in thread: 12V relay board BCS 462 on 04-06-2013 at 07:49 PM
    I'm sorry I'm not following you. So for instance connect the Green wire from the valve into
    NO4, but where do the Red and Black wires go?

  • Posted in thread: 12V relay board BCS 462 on 04-06-2013 at 07:01 PM
    My wiring is like the image attached.

  • Posted in thread: 12V relay board BCS 462 on 04-06-2013 at 04:53 PM
    This is just for liquids, not for gas. I did try and place the Black into the GND and the red
    and green into the VDD side (not at the same time). The ball valve does start moving (open for
    green and c...

  • Posted in thread: 12V relay board BCS 462 on 04-06-2013 at 05:14 AM
    So I'm having some difficulty with my valves and relay board. I bought a 8 relay module board
    12V see ebay: I have some 12V ball valves: have a 12V 2A power supply going into the VDD
    and GND of th...

0 COMMENTS
POST A COMMENT

Newest Threads

LATEST SPONSOR DEALS