Last Activity:11-05-2013 6:31 PM
Posted in thread: sanyo kegerator question on 08-21-2011 at 10:16 PM
the problem is these barrels flare out a bit in the middle. they have a smaller daimater atht
etop and bottom and are wider in the middle. I may try putting some wood under one to maybe get
the 2 of t...
Posted in thread: sanyo kegerator question on 08-19-2011 at 09:22 PM
Not sure if this one has been answered here. I bought 2 1/6th kegs from a local brewery, they
are somewhat shorter and fatter than the usual kegs.so getting them in side by side isnt
happening. I thin...
Posted in thread: CO2 regulators on 01-03-2011 at 05:39 PM
You get what you pay for. I've got a cheaper regulator, but it leaks every few months or so,
then I have to fix it. It's not a big deal to me because of the price, but some people might
not want to de...
Posted in thread: CO2 regulators on 01-03-2011 at 01:40 PM
Helo, I am looking for some recomendations for a dual gague co2 regulator. With my kegerator
set up I will be running 2 separate kegs and eventualy will be kegging my homebrew so I want to
be able to ...
Posted in thread: perlick beer tower question on 12-11-2010 at 04:04 PM
thanx for the heads up jason, I was contemplating that since I want to remove the glycol lines
from my tower. Its been a pita so far between the foam and the shanks wrapped in aluminum foil.
it will m...
Posted in thread: perlick beer tower question on 12-11-2010 at 01:06 PM
man what a pita, so I cut the wrench but have a hard time getting it over the nut due to all
the insulation they have in there. The other links I found mentione dchannel lock pliers and a
lot of patie...
Posted in thread: perlick beer tower question on 12-10-2010 at 03:20 PM
cut the craftsman then take it back to sears and tell them i broke while using it. ive heated
wrenches up before to bend them to get them in the perfect spot on the car then exchanged them
Posted in thread: perlick beer tower question on 12-10-2010 at 01:15 PM
Does the top come off that baby? My 2 tap tower does and you can get at the fittings that way.
Soak it in hot water and oxyclean to get it clean. Run beer line cleaner through the lines and
you may be...
Posted in thread: perlick beer tower question on 12-09-2010 at 11:31 PM
I recently picked up a 3 tap perlick tower for my kegerator project. it has t been used in some
time and the beer lines are prety nasty looking. I figured I would just replace them with new
ones. I re...
Posted in thread: Refigerators for a kegerator on 10-11-2010 at 06:12 AM
breath**ahem* Sorry, as a parent I just had to let that out. ;)I know I know, I anticipate
loosing tons of my ...