Tomahawk

LATEST ACTIVITY

• Posted in thread: problem with jaybird false bottom on 01-01-2013 at 11:24 PM
  I'm disapponted to see no replies to this thread. I had the same issue this weekend (hinged
  false bottom in keggle, pump on, low heat applied, stiring mash, grain under FB clogged my
  tube). I hope you...

• Posted in thread: OG well below target...can it be fixed? on 01-01-2013 at 01:39 PM
  Should I retire the keggle mash tun? How did I end up with 1-2lbs of grain under the false
  bottom (climax, hinged)?Strike water in, grain in, dough-in, check temp, good, let sit 10min,
  check temp, too...

• Posted in thread: OG well below target...can it be fixed? on 12-31-2012 at 03:42 PM
  I was just researching session IPA (or perhaps pale). It looks like I'll have a very expensive,
  light body, 64 IBU, 4.7% pale ale? I appreciate the idea of having DME on hand to adjust. I
  just never t...

• Posted in thread: OG well below target...can it be fixed? on 12-31-2012 at 02:49 PM
  I had the same problem. I did an all-grain that should have been 1.08 OG, and got 1.065 using a
  rubbermaid mash-tun with braided SS filter.The cooler wasn't my problem, I've always reached my
  target O...

• Posted in thread: OG well below target...can it be fixed? on 12-31-2012 at 02:13 PM
  I fired up my single tier keggle system for the first time yesterday. I brewed a 5gal
  Celebration clone with 13lbs of grain. I had an issue with mash that has lead to low
  efficiency. I was having trou...

• Posted in thread: Whirlpool w/pump question on 12-11-2012 at 01:07 PM
  Ahha! I wasn't thinking about killn' germs. Thank you!

• Posted in thread: Whirlpool w/pump question on 12-10-2012 at 07:15 PM
  I have my keggles complete on my new s/tier system. I'm going over the process in my head and
  one question I have is when to start/stop whirlpool.Starting the whirlpool (march pump, side
  pickup, side ...

• Posted in thread: Possible new Homebrew club? on 12-10-2012 at 06:57 PM
  There's the Stilly Mashers in the Arlington area.....it's small.

• Posted in thread: Propane...Low Pressure, high pressure, orifices? What does it all mean? on 12-09-2011 at 08:28 PM
  for the 10" burner, remove the gas fitting, turn the pipe thread side up and the small opening
  gets drilled out to 3/32", that is all that is needed for conversion to low pressure. If after
  test firin...

• Posted in thread: BG14 low pressure conversion? on 12-08-2011 at 01:28 AM
  Let me digest that for a while....Thanks for the responses gents!