Last Activity:01-12-2014 9:37 PM
Posted in thread: Ss false bottom ?s on 12-20-2012 at 09:03 PM
Thanks Golddigge. I was thinking that the plate apparatus was too big of a hassle. But I didnt
know if someone else could see something good in it. Any ideas other than a mash screen for the
rest of i...
Posted in thread: Ss false bottom ?s on 12-20-2012 at 08:41 PM
Just scored 6 or seven of these stainless trays with perforated ss plates on top. The
perforated disk is 12.5" in diameter and has a 1 5/8" hole in the middle. It has 4 tabs welded
on the bottom that ...
Posted in thread: 20 Gallon AG Set-up and 14.5 Conical For Sale on 12-16-2012 at 06:35 PM
Posted in thread: 2011 Simcoe, CTZ, & Cascade Pellet Hops T90 on 10-19-2012 at 04:05 PM
I started a dispute a few days ago and still haven't heard anything. If I do I will happily end
the dispute and just get my hops bit it has been 3 weeks.
Posted in thread: Temperature probe location on 10-17-2012 at 03:36 AM
I have an analog Johnson controller that I thought was a 3 degree differential but I will have
to check. With that controller if I put the probe near the carboy but not attached and I set it
at the lo...
Posted in thread: Temperature probe location on 10-16-2012 at 01:59 AM
I have a temperature controller for an extra fridge that we have. I mainly make ales and I have
a couple of questions. 1. Should I secure the temp probe to the side of my primary carboy?2.
Should I se...
Posted in thread: Transferring from corny to Sanke on 10-14-2012 at 11:54 AM
Thanks. I do not have the tool to remove. I am hopefully going to mess with it today to see if
I can do it. I will let you know how it goes.
Posted in thread: Transferring from corny to Sanke on 10-14-2012 at 12:59 AM
I am wondering if there is anything special I need to do or if I will cause problems by
transferring a carbonated beer from a corny keg to a Sanke keg. I want to do so in order to
travel with the Sank...
Posted in thread: 2011 Simcoe, CTZ, & Cascade Pellet Hops T90 on 10-12-2012 at 07:51 PM
I think something might have happened to him again. I ordered a couple of pounds and he said
they shipped, but I didn't get a tracking number and I haven't received the hops. I have tried
to contact h...
Posted in thread: 3/4" male cam locks for free on 10-08-2012 at 12:47 AM
Thanks. Money sent.