VIEW MY

TimGrz

Gift Premium Subscription To TimGrz

Join Date:

08-01-2008

Last Activity:

11-30-2011 3:12 PM

    ABOUT ME

  • Female
  • Single

LATEST ACTIVITY

  • Posted in thread: Carboy/ Keg Cleaner Giveaway on 06-22-2011 at 09:04 AM
    ME! ME! ME!/tg

  • Posted in thread: Keg identification on 04-23-2010 at 12:33 PM
    With three ball lock fittings and proper poppets for them... They will all work with ball locks
    fittings regardless of the exact type?So I am assuming that all I need to make sure I have the
    correct p...

  • Posted in thread: wiring new plug/cord on salvaged washer motor? on 11-10-2008 at 07:34 PM
    You could also splurge and go down to Harbor Freight and spend the $2.99+tax on a digital
    multi-meter and trace the lines. Good practice and you will learn from it.Those cheap
    multi-meters are great t...

  • Posted in thread: Heating Elements? on 10-28-2008 at 07:52 PM
    to here... but being that a PID and something like a LOVE are so comparable in price, when
    is one preferred over the other? ...and why?/tg

  • Posted in thread: Heating Elements? on 10-27-2008 at 08:43 PM
    A PID is basically a temperature controller like a Ranco or Love control with the added feature
    that it uses a complex mathematical equation to control the relay. With a Ranco or a Love
    control it tak...

  • Posted in thread: Heating Elements? on 10-26-2008 at 11:06 PM
    You will need to control the voltage to stop boil over. If you use a PID with manual control
    you can lower the output to the element.Okay, I know a PID is...A
    proportional–integral–derivative controll...

  • Posted in thread: Heating Elements? on 10-24-2008 at 05:15 PM
    Rooster,Take into account that if you were to get a low, or ultra low density element, you can
    have wort in direct contact without caramelizing the wort.I did a search to find out the
    explanation of w...

  • Posted in thread: For my next DIY project... new kegerator on 10-22-2008 at 02:59 PM
    I would be pretty darn hesitant to do anything to the enclosure so as to keep it "original."
    From the picture all but the back looks intact.I would go with some sort of Irish Coffin that
    sits on top, ...

  • Posted in thread: My "Bling" Keezer on 10-20-2008 at 09:41 PM
    Here is the "exhaust" hole. It's about 3.5". The garage is a bit warmer today, but the inside
    of the compressor box is still only about 3-4° warmer than the ambient air of the garage. The
    sides are st...

  • Posted in thread: My "Bling" Keezer on 10-20-2008 at 08:31 PM
    slimer, No worms... it's all good. Other thoughts / ideas is why I posted this.The whole
    freezer system removes heat from the inside and lets it go outside. It does this by compressing
    the gas which c...

0 COMMENTS
POST A COMMENT