- Posts 12
Last Activity:05-25-2016 11:29 PM
Likes Given: 6
1 Likes on 1 Posts
Posted in thread: Red Chair NWPA clone on 08-30-2015 at 12:31 AM
I forgot to add carastan malt to my batch. How much effect will this have on it?Probably going
to lose the color and some flavor.Malt Properties from a few different web sites:Carastan is a
Posted in thread: Red Chair NWPA clone on 09-25-2013 at 05:09 PM
I've made this brew 4 times now, and actually just racked to kegs last night.I add the 0min
hops at FO and just let them sit while my immersion chiller is doing its thing. So they're
probably in there...
Posted in thread: Blowing through c02 on 09-16-2013 at 05:29 PM
Check out this thread, it has some pictures of what you'll want to look for. and as the last
gif points out, it could even be a ball lock connection that's bad.
Posted in thread: Red Chair NWPA clone on 06-03-2013 at 02:00 PM
H2o requirements all depends on your system so you might have to tweak it a little. I do 10 gal
batches and here's the water measurements I used to make this. Mash In/Strike Water:8.75 gal
Posted in thread: Kegging Question on 04-24-2013 at 04:09 PM
+1 for LBussy advice.I've done this same thing and as long as everything was cleaned/sanitized
you'll be fine.The key thing when burping a keg with that much air space is to really pump up
the PSI to ...
Posted in thread: HELP! Do I need a blowoff tube? on 04-24-2013 at 04:00 PM
Thread here about blow off tubes and buckets. Pics inside thread of examples.
Posted in thread: Red Chair NWPA clone on 04-24-2013 at 03:55 PM
I have all the ingredients ready and can't wait to brew my Red Chair.....Any pointers?I'd say
follow the OP instructions and adjust subsequent brews to your liking. It's a very solid very
Posted in thread: Red Chair NWPA clone on 04-02-2013 at 12:13 AM
12 Thumbs up for this brew .... literally.Family called a few months ago and said they were
coming in town for Spring Break. I had a 5 gal keg of this ready when they got here. 7 family
members and my...
Posted in thread: trouble with kegging on 08-08-2012 at 06:48 PM
Yes - when screwed down there should be sufficient pressure to create a seal between the
connections. It should not move.Also, check the tube itself. I had a C02 leak which I thought
was a bad o ring,...
Posted in thread: Set and forget carbing method on 08-08-2012 at 06:30 PM
Using the below chart I carb for 7 days and test it. If it's not where I want it I leave it and
test it each day.After 10 or 11 days if it's still under carbed I'll jack the PSI up a bit,
maybe by .5 ...