Last Activity:07-02-2014 8:03 PM
2 Likes on 2 Posts
Posted in thread: Wort Monster Giveaway on 04-23-2014 at 08:49 AM
Posted in thread: My insane 25 Gal, 100 Percent Hard Plumbed Tri-Clover, Automated Tippy Build on 01-18-2014 at 04:51 PM
Hmmmm.......I don't THINK, that any of those "tri clover" fittings are cast.The "polished" vs.
"machined" look is probably from the polished one going into a "vibratory" de-burring /
Posted in thread: My insane 25 Gal, 100 Percent Hard Plumbed Tri-Clover, Automated Tippy Build on 01-16-2014 at 04:28 PM
It was my understanding that there was no internal polishing done after welding sanitary tube -
as long at there is not excessive reinforcement on the internal side of the weld you are
Posted in thread: Dip tube for tri-clamp keggle on 01-13-2014 at 04:49 AM
I whipped three of these off for a friend who is putting together a new build using tri-clamps.
I've seen a couple of different ways of mounting dip tubes in a tri setup such as using a
stopper or ori...
Posted in thread: Spike Brewing 12.5 Gallon Conical Fermenter Giveaway! on 01-06-2014 at 02:16 PM
Hope springs eternal.... ahhh, who am I kidding?
Posted in thread: new Northern Brewer catalog. megapot 1.2 on 01-04-2014 at 03:53 PM
I'm looking to go to step up to 100 qt, maybe as soon as next week and thicker walls are
attractive from a welding perspective. I don't want to weld on less than 1.2mm .It might be
thicker than some o...
Posted in thread: Rebel Brewer Giveaway! on 11-22-2013 at 06:01 PM
Count me in
Posted in thread: DIY Walk In Cooler Build on 07-10-2013 at 12:54 PM
I'm still rather surprised that you don't need a permit, for the electrical anyway.
Posted in thread: StainlessBrewing.com Summer Giveaway! on 06-27-2013 at 01:30 AM
Posted in thread: Keg/Carboy washer & line cleaner on 04-11-2013 at 05:08 PM
Sorry for the tardy reply. I'm finishing up my second week of night shifts and don't spend much
time online when I'm doing them.The couplers are both Hansen. Part numbers B4HP26 & B4KP26. I
also used ...