Last Activity:08-28-2015 2:20 PM
Likes Given: 1
2 Likes on 2 Posts
Posted in thread: Using a smaller false bottom (diameter) in larger kettle? on 08-28-2015 at 02:20 PM
Not at all. I have the exact setup that you describe. Use a rigid piece of pipe and I would use
the FB sold at adventures in homebrewing too. Here is mine. Couplings are soldered
Posted in thread: Using a smaller false bottom (diameter) in larger kettle? on 08-27-2015 at 03:06 PM
You could see a slight change in efficiency, but it's negligible IME. I used to have a round
cooler-based mash tun. I switched to a stainless pot mash tun and use the same FB that I used
in the cooler...
Posted in thread: Using a smaller false bottom (diameter) in larger kettle? on 08-27-2015 at 03:53 AM
What are the downsides, if any, of using a smaller false bottom in a larger mash tun /
kettle?My stainless mash tun will be roughly 15-15.5" in diameter. I understand that using the
largest fitting fa...
Posted in thread: Danby DAR440BL or Frigidaire LFPH44M4LM owners, could you post interior dimensions? on 05-30-2015 at 07:40 PM
Shoot! Any owners out there?
Posted in thread: Danby DAR440BL or Frigidaire LFPH44M4LM owners, could you post interior dimensions? on 05-27-2015 at 01:20 AM
I've been searching all over for the (exact) interior dimensions of the Danby DAR440BL and/or
Frigidaire LFPH44M4LM mini fridges and was hoping someone who owns one could take some
Posted in thread: Which way is the nylon washer between the CO2 regulator and tank supposed to face? on 11-22-2014 at 09:59 PM
Between the CO2 regulator and CO2 tank goes the round nylon washer. It has a smaller side that
"pokes out" and a larger flat side. Which side is supposed to face the regulator and which side
Posted in thread: Kegerator Build Igloo 4.6 FR465, Haier HNSE05, Kenmore 183.94679 and possibly others on 07-13-2014 at 06:32 PM
You can fit two corny kegs in the igloo fr464. You just have to remove the compartment panel on
the door.210907 Sent from my iPhone using Home BrewSo I have definitely seen that you can get
two kegs i...
Posted in thread: Kegerator Build Igloo 4.6 FR465, Haier HNSE05, Kenmore 183.94679 and possibly others on 07-13-2014 at 05:03 PM
Can anyone that has the IGLOO FR464 or FR465 confirm the internal dimensions of this fridge
(including dimensions for the hump, too)?Also, could two 9" diameter kegs fit side by side in
this thing wit...
Posted in thread: Danby DAR125SLDD Kegerator Build on 07-12-2014 at 01:28 AM
You're right. I went back and checked my model and it's actually the DAR044A2SLDD. Sorry, my
bad. Sent from my iPad using Home BrewCool! Thanks for checking that!
Posted in thread: Danby DAR125SLDD Kegerator Build on 07-11-2014 at 08:27 PM
The side mounts can be removed, it's just more work b/c you will have to cut them out and then
seal the cuts to protect in insulation. I've seen other builds on here where people have done
that. I did...