VIEW MY

the_Roqk

Gift Premium Subscription To the_Roqk

Join Date:

02-13-2007

Last Activity:

11-21-2015 1:26 PM

Likes Given: 1

1 Likes on 1 Posts 

    ABOUT ME

  • Central Florida
  • Homebrewing,Golf,streaking,and anything else thats within reason.
  • S.E.R.D.
  • Rock
  • Zeppelin, Stones, ZZ Top, 60's, 70-80's rock N roll
  • me, myself and I
  • Brewed a couple of DME beers about 9 yrs ago and wasn't satisfied. Waited till I was able to learn more and get better equipped. Now I'm brewing good beers and starting not to like BMC beers.
  • Male
  • Single

LATEST ACTIVITY

  • Posted in thread: No airlock lid?! Blow off Emergency setup on 11-20-2015 at 10:58 PM
    When I first started I had the same issue. After getting everything done and prepped for the
    airlock I couldn't find the top to the 3 piece bubbler. So, I decided to put a tube on the top
    end and put ...

  • Posted in thread: Upright Keezer, 8 taps, 11 kegs on 11-20-2015 at 08:30 PM
    Bit the bullet and made two holes to the right and above the inside back panel (hump). This was
    done with a 1/8" bit and barely drilling through. Then I used a 12 gauge bare copper wire to
    probe the h...

  • Posted in thread: Upright Keezer, 8 taps, 11 kegs on 11-19-2015 at 12:08 AM
    Thanks for the reply back. Yes, I'm familiar with the old cornstarch method of finding the
    coolant lines. Used to have a little Sanyo two corny keggerator that was sweet before it bit
    the dust. That s...

  • Posted in thread: Upright Keezer, 8 taps, 11 kegs on 11-18-2015 at 09:13 PM
    It's been a while since I've posted on this site so bear with me. I recently purchased a
    Fridgidaire 20 cu ft model (frost free-no coils in the shelves) to convert like the OP. I have
    gone over all of...

  • Posted in thread: frist batch of beer quetion on 07-09-2011 at 01:30 AM
    Give it a couple weeks in the secondary and then see what your gravity reading is. The yeasties
    appear to be eating again. Keep checking on it and take gravity readings the last 3 days of the
    second w...

  • Posted in thread: frist batch of beer quetion on 07-09-2011 at 01:12 AM
    hey thanks for the infoi did move the beer over to the secondary on 7/4 i took 2 gravity
    readings... #1 at around week 3 wich came to be 1.020 and a nother one 6 days lattter and it
    was the same..Hmmm...

  • Posted in thread: frist batch of beer quetion on 07-08-2011 at 06:27 PM
    QUOTE=baddagger: well my frist brew has been in the primary for 3 week today.. and the beer
    still looks very dark.. now the beer is a raspberry wheat beer with citrus add's now i added
    1.5 pounds of r...

  • Posted in thread: poor efficiency on 06-30-2011 at 12:18 AM
    I agree with djsethall. Do you crush your own grains or do you have your LHBS do the crushing
    for you? Not sure also if it could be a bad batch of 2 row. Sometimes that can happen. If
    that's the case ...

  • Posted in thread: frist batch of beer quetion on 06-29-2011 at 11:59 PM
    First of all... relax. Not really sure of what it could be. All I've seen is that you have a
    wheat based beer that has been fermenting for the past 3 weeks and you seemed worried about the
    raspberry f...

  • Posted in thread: DIY Motorized grain mill... on 06-23-2011 at 12:26 AM
    Nice and Sweeeeet! You'll like the fact that you have the mobility for the cart. Also at 40
    inch lbs of torque you are right there for a good crush and it shouldn't bog down at all
    providing you have ...

0 COMMENTS
POST A COMMENT