Last Activity:11-25-2013 7:27 PM
Posted in thread: Control Panel on 11-16-2013 at 01:30 AM
Hi everyone I am have a little issue with my control panel. Every time when it is on and there
is liquid on the stand I can feel electric current running through the water. Not a lot but
enough to kno...
Posted in thread: Problem using silicone tubing on 10-18-2013 at 04:06 PM
I switched to using silicone tubing for brewing and I loved it except I had problems when the
silicone got hot the hose clamps I used ate into the silicone hose causing it to make holes. I
am using yo...
Posted in thread: Yeast Starter on 09-28-2013 at 03:50 PM
Hi everyone, I was going to make a yeast starter but realized I was out of DME but I have extra
grain. I should be able to steep the grain until I get a O.G. I want for my starter? Has anyone
Posted in thread: 2- 10" Propane Burners and 2- 6" Stainless Steel 1/2" MNPT Thermowells on 09-26-2013 at 10:13 PM
Yes it is this sale is for both!
Posted in thread: 2- 10" Propane Burners and 2- 6" Stainless Steel 1/2" MNPT Thermowells on 09-23-2013 at 09:26 PM
Hi everyone,I have some items up for sale. I had planned on building a HERMS system with a
propane system but went ended up making a electric system instead so I have these brand new
never used 10" Lo...
Posted in thread: Pump problems on 08-25-2013 at 11:48 AM
Well here is what happened, I was testing out all my electrical components in my control box
and tried out my switches and wanted to test out my pumps. I have quick disconnects and I
hooked up one to ...
Posted in thread: Pump problems on 08-24-2013 at 07:08 PM
Hi everyone, I have been building a HERMS system and I have ran into a bit of a problem. My
pumps aren't going to have enough power to push my liquids around on my stand. I have two March
809 115 volt...
Posted in thread: silver solder on 10-18-2012 at 01:34 PM
Alright sounds good, thanks for the info.
Posted in thread: silver solder on 10-17-2012 at 01:56 PM
I bought silver solder to use with soldering a couple of couplers to a boil kettle. The solder
had a low melting point at 450 degrees which made it easy to work with but I didnt take in
Posted in thread: fixing a leaking welded coupler on 07-15-2012 at 01:45 PM
Hi i have a welded coupler on one of my sanke keg kettle and i was wondering if anyone knows if
you could use JB weld to take care of the leak and if there is any drawbacks?Cheers, Andrew