Last Activity:07-02-2015 11:50 AM
Likes Given: 1
2 Likes on 2 Posts
Posted in thread: Plastic Fermenter Lid / Seal Problem Solved! on 05-13-2015 at 11:53 AM
Have a similar setup and have struggled with the gasket. Where did you get yours at?Gasket is
1/4" water-jet cut nitrile rubber.
Posted in thread: Brewmasters Warehouse on 03-21-2015 at 01:54 PM
I too have probably spent thousands of dollars with them. I mainly stayed with them because I
always bought my recipes in bulk so timing was not a issue. I finally gave up last fall and
began buying s...
Posted in thread: Cheap Plastic Conical Fermenters on 03-07-2015 at 02:40 PM
I have three 10 gallon DEN HARTOG INDUCTOR TANKS that I have been using for years. Very easy to
convert. Built my own stand out of 3/4 inch plywood.If you need help I would be glad to
help.This is whe...
Posted in thread: Auber on 12-09-2014 at 12:53 PM
I have totally gone electronic with my smoker and brewing equipment. Aubers are the easiest
vendors that I have ever worked with. Had a SSVR relay that didn't work. Called them and a new
one was in th...
Posted in thread: Auber Digital SSR Power Regulator on 11-20-2014 at 01:59 PM
Bought both of these and mounted them in a control box. Installed a 22 mm Flashing Buzzer to go
with the timer. Don't know how I got along without it.Digital SSR Power Regulator for Wort
Posted in thread: Brewmasters Warehouse on 01-24-2014 at 11:53 PM
I went ahead and ordered from them again based on the recent positive feedback. Not happy so
far...started out good with immediate order confirmation e-mail...that was Friday afternoon. I
have yet to ...
Posted in thread: Brewmasters Warehouse on 11-26-2013 at 12:13 PM
Had to place a rush order Friday for a Homebrew class I am teaching this weekend. BMW got right
on it and it will be delivered today.Thank You, Very MuchTD
Posted in thread: Can A PWM Deliver True 100% Duty Cycle? on 10-08-2013 at 11:51 AM
That's what I'm using now (it's a cheaper one) but it's quite simple. Like I said, it works
well, but it has such a high frequency that it gets pretty hot.Could you explain? What gets hot
the SSVR or ...
Posted in thread: Brewmasters Warehouse on 08-08-2013 at 11:56 AM
Ordered on Aug 2, Order recieved on Aug 7, brewing on the 8th. Cannot and will not
Posted in thread: HDPE conical - to bleach or not to bleach? on 07-05-2013 at 12:57 PM
HDPE will take a fair bit of heat...if you have the ability to fill it w/ 200 degree water?I
don't think bleach will hurt HDPE if rinsed repeatedly w/ hot water.I agree. I have a similar
setup as you....