Gift Premium Subscription To swstim

Join Date:


Last Activity:

01-05-2016 3:22 PM

Likes Given: 1

2 Likes on 2 Posts 


  • Electrical Engineer
  • Tim
  • Started with extract in 2011. Soon afterwards I built a single tier Keggle electric brewery.
  • Always 10g of an IPA-something and maybe 5-15 or something else.
  • 4 on tap at all times
  • Male
  • Married
  • Madison
  • WI


  • Posted in thread: Brewtarget 2.0 Update on 04-09-2013 at 06:45 PM
    What settings / variables should I change to actually get 152 (4 degrees higher) for the mash
    temp?I have the same issue with a similar setup. Increase the mass of your setup to account for
    it. Are yo...

  • Posted in thread: Hopalicious clone on 03-15-2013 at 02:01 AM
    And the results... (recipe in post #8 above)Mine on the left, commercial Hopalicious on the
    right.First impressions - They're very close. Closest clone I've done.Color - Clone is slightly
    too dark. I ...

  • Posted in thread: Bell's Two Hearted Ale Clone (close as they come) on 02-08-2013 at 03:06 PM
    I used gelatin for my brew of this clone and I wish I hadn't. It cleared up too much!

  • Posted in thread: Hopalicious clone on 02-04-2013 at 04:25 PM
    I brewed a Hopalicious clone yesterday using DuffMantt's advice. I "only" did 8 hop addditions.
    :) Recipe is below. I'll report back in a few weeks and let you know how it went!Batch Size:
    5.25 gal OG...

  • Posted in thread: Soldering Stainless steel on 01-16-2013 at 03:05 PM
    I soldered short ferrules into my kettle. Clearance with the wings on the clamp can be tight
    depending on orientation, but I don't find it to be an issue. I dimpled outward and pushed the
    ferrules in ...

  • Posted in thread: Soldering Stainless steel on 12-28-2012 at 02:38 AM
    Hey guys, I learned how to do this somewhere in this thread but I don't know if anyone's made a
    concise post about it yet. :)I was successful soldering in a element adapter kit from
    StillDragon to com...

  • Posted in thread: Soldering Stainless steel on 12-12-2012 at 05:08 AM
    Woo! First soldered keggle fitting is a success! Thank you HBT for showing me the way. It only
    took 1 old lid riddled with holes, 2 broken bolts, 3 tries at making forming tools on the
    lathe, and 4 ba...