Last Activity:05-03-2015 12:56 PM
2 Likes on 2 Posts
Posted in thread: Bathtub Brewsink? on 10-01-2014 at 03:39 AM
+1 to getting a pre-rinse faucet, built a kal clone eherms last year and my rinse faucet turned
out to be my favorite upgrade! I expect to see a lot more bathtub sinks on here in the future.
Posted in thread: Bathtub Brewsink? on 10-01-2014 at 03:29 AM
It might be hard to fit a 3/0 door into a 32-1/2" rough opening. :cross:If you are planning on
a 36" door down there, I'd check into that. A 30" door kinda sucks on the exterior.Ha! I never
Posted in thread: Bathtub Brewsink? on 09-29-2014 at 05:17 PM
Good call. I think we'll have the floor space and my brother and I (the primary users) are both
6'5". I think it will be crucial to get the right faucet and place it smartly so it doesn't get
Posted in thread: Bathtub Brewsink? on 09-29-2014 at 04:59 PM
Posted in thread: Bathtub Brewsink? on 09-29-2014 at 03:40 PM
Here's the brewing room floor plan:
Posted in thread: Bathtub Brewsink? on 09-29-2014 at 03:38 PM
We are just finishing up building our new house where I roughed in a brew room in the basement
(to be finished slowly over the years). I ran hot/cold water, drainage, Nat gas, 110 & 220v as
well as an...
Posted in thread: Cereal Mash Attempt on 10-27-2012 at 12:24 AM
You guys enjoying this addition to your process? I'm going to give this a go in a couple of
weeks. Probably stove stop for the cmash.Enjoy? Ummmm....I definitely enjoy the body and taste
of the beer i...
Posted in thread: Cereal Mash Attempt on 08-08-2012 at 03:06 AM
Yep, although lately I've been doing 75-90 minute mashes with the more traditional beers. I
thought of increasing the time on this one as well. I don't think it's needed, especially
considering all th...
Posted in thread: Cereal Mash Attempt on 08-07-2012 at 02:12 PM
I've done this a few times since the post; it gets easier once you get the rhythm. I got low
efficiency when i started too. My fix for that was making sure my batch sparge had enough
heat/volume to ge...
Posted in thread: Homemade Mash Paddle Pics on 01-10-2012 at 02:31 PM
Is that a wood burnt stamp, or did he do with that with a normal burning iron? Either way