Last Activity:11-19-2015 11:45 PM
Likes Given: 1
19 Likes on 13 Posts
Posted in thread: Mash pH way low.. Where did I go wrong? on 09-11-2015 at 12:39 PM
I don't know about Briess but when I use Rahr pale malt my pH is normally .3 lower than all the
Posted in thread: new to competitions - need help categorizing my brews on 09-11-2015 at 12:48 AM
Enter the same beer in multiple categories. It's more expensive but there's no way to know how
the judges will behave IMO.
Posted in thread: Azacca hops on 09-06-2015 at 08:42 PM
I've used it a couple times and I have to agree that it is more subtle than say something like
citra or simcoe.10 lbs 8.0 oz Munich (BestM√lz) (12.0 SRM) Grain 1 93.3 % 8.0 oz Honey Malt
(25.0 SRM) Gr...
Posted in thread: Brew today. Pitch tomorrow? on 08-14-2015 at 11:54 PM
I do this every time. Getting my wort to pitching temp, especially for lagers, is impossible
with my tap water in the summer.Brew sunday, stick it in the fridge, pitch monday afternoon
Posted in thread: HOWTO - Make a BrewPi Fermentation Controller For Cheap on 08-10-2015 at 10:59 PM
Interesting observation, I pulled the code for this public page from here. You're right it does
call on a div id of beer-panel which doesn't show up anywhere in the reference file of
Posted in thread: HOWTO - Make a BrewPi Fermentation Controller For Cheap on 08-10-2015 at 10:21 PM
page works without issue with public and internal network access but my public.php page
Posted in thread: HOWTO - Make a BrewPi Fermentation Controller For Cheap on 08-08-2015 at 11:52 PM
that's what it looks like when the heater you have installed is too powerful. Had to set the
hair dryer to lowest settings to get it to stop moving the beer 2 degrees every time it kicked
on for the...
Posted in thread: pH Meter Calibration on 04-21-2015 at 08:24 PM
How long did you have the batteries out yesterday? It can take a few minutes for the memory to
clear so it will hard boot. I also wondered about leaving batteries out but decided since I now
know the ...
Posted in thread: pH Meter Calibration on 04-21-2015 at 01:26 AM
Looks like it's working again.I tried the battery thing yesterday and it didn't do
anything.This time I had it on and popped the batteries out while it was running. Left them out
the whole time it too...
Posted in thread: pH Meter Calibration on 04-21-2015 at 01:09 AM
I did as AJ suggested I do before calling up Hach and removed the batteries...I'm assuming this
causes a hard boot situation. Anyway, that is all that it needed, it went from refusing to to