Last Activity:01-18-2014 1:27 PM
Likes Given: 35
22 Likes on 17 Posts
Posted in thread: DIY 5L Mini Keg Carbonator Bung(onator) on 08-15-2013 at 12:53 PM
No issues with denting. The biggest issue I ran into was you still need to let the carbonic
acid dissipate for the beer to taste best after a force carb.I'm not sure about the avanti
Posted in thread: Brewer's Hardware 15 Gallon Stainless Steel Conical Fermenter Giveaway! on 07-27-2013 at 03:39 AM
Want to touch the shiny!
Posted in thread: DIY glycol chilled plastic conical fermenters on 07-24-2013 at 11:09 AM
Looks good. Maybe I missed it some pages back, but why are you using glycol and not water?
Looks like you have the temp above freezing, and water is better at heat transfer than
glycol.....I think he ...
Posted in thread: DIY Walk In Cooler Build on 07-24-2013 at 02:58 AM
So I checked out the floor this morning before I left for work. It looks OK but not level
enough. So I'll stop at the Despot on the way home and pick up another couple of bags of
underlayment and see ...
Posted in thread: DIY glycol chilled plastic conical fermenters on 07-24-2013 at 02:43 AM
Obviously the tanks are holding temperature well but the reservoir really seems to climb quiet
a bit. Do you think you could use a larger reservoir for more thermal mass?Three lagers at once
could be ...
Posted in thread: Which breweries to visit while in Portland on 07-04-2013 at 12:28 PM
Ill be out there next week for work. Subscribing, thanks everyone for the comments.
Posted in thread: DIY glycol chilled plastic conical fermenters on 06-25-2013 at 12:33 PM
Is she up to cruising altitude yet? How often do the zones and main reservoir ac kick on?
Posted in thread: Revvy's Belgian Blonde (Leffe Clone) on 06-20-2013 at 10:59 AM
The temperature has been maintained at 19C for the last 2 weeks by my heated
jacketsteve19c/~66f is a bit low to finish.I would bump up the temp to 70F and see if they
finish. Belgian strains are freq...
Posted in thread: TeensyPi Networked Temperature Controller on 06-19-2013 at 10:47 AM
I don't really understand how in the application this would be applied to on here (temps
generally from 0-100°C) a thermocouples range would be an advantage over the DS18B20?According
to maxim, the st...
Posted in thread: DIY Walk In Cooler Build on 06-18-2013 at 02:01 AM
The trick with avoiding condensation is to keep the warm moist air far enough away from the
cold surface to avoid dropping below the dew point. The nice thing you have going for you is an
arid AZ clim...