VIEW MY

ssgross

Gift Premium Subscription To ssgross

Join Date:

04-11-2009

Last Activity:

04-19-2014 10:46 PM

3 Likes on 2 Posts 

    ABOUT ME

  • Female
  • Single

LATEST ACTIVITY

  • Posted in thread: Best (inexpensive) Drill for Grain Mill - Harbor Freight? on 04-15-2014 at 02:29 PM
    it is the same drill as your link. The D handle is removable. The side grip can be installed on
    either side or the top. The holes accept an M10x1.5 bolt. At first, the shaft and the chuck
    were not exa...

  • Posted in thread: Best (inexpensive) Drill for Grain Mill - Harbor Freight? on 04-14-2014 at 01:02 PM
    I think you are mistaken. it is a magic table, as evidenced by my beer not pouring out. I dunno
    what's up (pun intended). they are fine on my computer and phone. I'll fix it after work.

  • Posted in thread: Best (inexpensive) Drill for Grain Mill - Harbor Freight? on 04-13-2014 at 04:19 PM
    My drill came in on Friday. After pancakes for the kids on saturday, and a trip to lowes, I set
    to work building a mill table and finished late afternoon in time to put a few coates of clear
    latex bas...

  • Posted in thread: Automated Flow Rate Control on 04-10-2014 at 01:35 PM
    For BCS users, there is a thread on the ecc forums about "tricking" a temp input to read volume
    using the sensor referenced above. was back in 2012. Any other BCS'ers out there played with
    this?I don...

  • Posted in thread: Show us your sculpture or brew rig on 04-09-2014 at 06:59 PM
    Rhode Island Red hen?fried chicken flavored beer? why not - i've seen bacon beer.

  • Posted in thread: Automated Flow Rate Control on 04-09-2014 at 01:46 PM
    What do you mean by volume feedback? I Google and found lots of 12v dc diaphragm pumps that say
    "X liters per minute", but nothing with volume feedback. are you describing something with a
    variable fl...

  • Posted in thread: Best (inexpensive) Drill for Grain Mill - Harbor Freight? on 04-03-2014 at 05:52 PM
    since so many people went with the harbor freight drill above...I was wondering if it had
    enough oomph to start the mill with grain in it, or if you had to start the mill first, and
    then add your grai...

  • Posted in thread: Automated Flow Rate Control on 04-03-2014 at 02:52 PM
    what is the input voltage on the RC motor?I have never set up an arduino, however this has been
    on my bucket list for a while now. I have a BCS driven system. I think I will put a float
    sensor to cont...

  • Posted in thread: Automated Flow Rate Control on 04-03-2014 at 01:13 PM
    From what I've read, motorized ball valves are either completely open or complete closedStill
    working on this. In another thread I asked about the time it takes the 1/2" motorized ball
    valves to open ...

  • Posted in thread: stainless keg connections? on 03-15-2014 at 05:23 PM
    New post oring with lube still leaked. When I swapped out the disconnect, no more leak. The old
    disconnect had a small piece of the bead chipped off. I suppose this could have happened if it
    wasn't ce...

0 COMMENTS
POST A COMMENT