VIEW MY

sredz

Gift Premium Subscription To sredz

Join Date:

08-02-2011

Last Activity:

04-16-2014 6:04 AM

2 Likes on 2 Posts 

    ABOUT ME

  • Male
  • Married
  • Muskego
  • WI

LATEST ACTIVITY

  • Posted in thread: Yeastcalc.com Down? on 01-28-2014 at 05:48 PM
    I really hope it comes back. That site has been great for calculating step starters!

  • Posted in thread: Basement Brew Room Build on 01-27-2014 at 01:27 PM
    Atjsparty- Iíve thought of adding some L or U channel to the hood, but Iím not sure this will
    solve the problem. The fan is oriented vertically and the opening is literally directly above
    the BK so it...

  • Posted in thread: Basement Brew Room Build on 01-25-2014 at 08:42 PM
    Thanks for the comments. I'm not sure yet how I will rectify the condensation problem. I think
    the problem is with the orientation of the fan being directly above the brew kettle. I may
    ultimately hav...

  • Posted in thread: Basement Brew Room Build on 01-25-2014 at 02:59 PM
    Thanks, I did a lot of looking before I put this together too. There are some great builds on
    this forum!

  • Posted in thread: Basement Brew Room Build on 01-24-2014 at 09:22 PM
    In the end, I am really pleased with the room. I have brewed in it twice so far (only once with
    the new sink). There will undoubtedly be some continued tweaking and additions, but for now,
    Iím up and ...

  • Posted in thread: Basement Brew Room Build on 01-24-2014 at 09:21 PM
    I purchased a stainless sink off a local auction for $100 - also scored a nice piece of
    stainless steel sheet from a relative that conveniently fits perfectly behind the sink. Found
    the sprayer on eba...

  • Posted in thread: Basement Brew Room Build on 01-24-2014 at 09:21 PM
    I have an Active Air 6Ē 400cfm inline fan. I mounted this on the ceiling directly above the
    hood. Itís a short run (about 2í) to the exterior of the house with just one elbow. The fan
    sits right over ...

  • Posted in thread: Basement Brew Room Build on 01-24-2014 at 09:20 PM
    I built a hood out of wood and FRP panel. I framed the hood with 1x12 pine and used 1/4" birch
    plywood for the top. Glued the FRP on the interior with panel adhesive and caulked all of the
    seams with ...

  • Posted in thread: Basement Brew Room Build on 01-24-2014 at 09:19 PM
    I built some shelving out of some extra 2x4ís I had laying around. was an old solid maple
    door in sitting in the room that was no longer being used (must have weighed 50 lbs!) Itís a
    really nice pie...

  • Posted in thread: Basement Brew Room Build on 01-24-2014 at 09:18 PM
    I framed in the waste stack. The sink will be placed just to the left of this. This is the only
    area of the room that will be drywalled. I installed some new lights on the ceiling. I ran
    some wire ...

0 COMMENTS
POST A COMMENT