Last Activity:07-19-2016 10:28 PM
5 Likes on 4 Posts
Posted in thread: Delayed dry hop on 06-29-2016 at 02:12 PM
Due to a new addition to my family, i dont get to brew as often as i would like. Unfortunately,
i still enjoy my home brew at the same rate so i am in danger of running out!! My staple brew
is an IPA,...
Posted in thread: Second Pour Foam on 05-03-2016 at 12:54 PM
So i built my keezer with three Perlick 650ss taps. the keezer is kept at ~42F , kegs are
pressurized to 12psi and the lines vary from 5' to 11'. when i grab my first pour, i usually
get a few ounces ...
Posted in thread: whirpool does not work on 05-03-2016 at 11:34 AM
ive never been able to effectively leave the trub in the boil kettle without:1) making a mess
(filters, screens, etc)2) too much effort (cleaning filters, screens, etc)3) leaving a
significant amount ...
Posted in thread: Mash PH and water profile question on 04-26-2016 at 10:42 AM
i have recently started paying attention to mash Ph and water. I got my water report and found
my Ph was a bit high for an ideal mash. I have been using acidulated malt in my last two brews
Posted in thread: Selecting a Heater - 125 litre Freezer on 04-22-2016 at 04:44 PM
This: cheap, you can cut it to any length you want.
Posted in thread: STC-1000 mounting options on 04-22-2016 at 04:41 PM
i did. i mounted a plastic electrical box and sealed up the holes/edges with silver foil tape.
Then i glued foam board insulation around the box. not only is it sealed from the inside of the
Posted in thread: Fermentation question - weird one on 04-05-2016 at 11:27 AM
is your bucket lid sealed?
Posted in thread: Confession Time on 04-04-2016 at 11:01 AM
While trying to reduce the amount of trub into the fermenter, i used a stainless steel scrub
pad around my kettle inlet as a strainer. After about a gallon it clogged and i couldnt free it
Posted in thread: Sticky LME on 04-04-2016 at 10:50 AM
I would put hot wort in it and dump it into the boil pot a few times.
Posted in thread: Early Morning Brews on 04-02-2016 at 07:26 PM
Fired the burner at 4:30. Finished by 10:30 including an extended whirlpool. 348437