Last Activity:07-22-2016 2:52 PM
Likes Given: 9
4 Likes on 4 Posts
Posted in thread: It's Finally Done: My 10-tap Keezer! on 05-20-2016 at 01:06 PM
I also had some problems with over-tightening the JG fittings (cracked the first two I tried in
half). You can't tighten them as you can a swivel-nut. I ended up hand tightening the JG
fitting as much...
Posted in thread: Three bottom-drain keggles on 04-03-2016 at 03:51 AM
The pictures don't seem to be loading.
Posted in thread: SS Ball Lock QD O-Ring on 01-27-2016 at 08:51 PM
I recently lost the o-ring out of my stainless steel ball lock QD (like this model) while I was
cleaning it. Does anyone know the o-ring size (it is slightly larger than the normal plastic
ball lock Q...
Posted in thread: HomebrewSupply Recipe Giveaway on 11-04-2015 at 03:01 PM
Posted in thread: Keg on its side on 08-07-2015 at 03:02 PM
If you are ordering used 3gal pin-lock kegs from AiH, most of the ones I received had straight
diptubes down one side of the keg. I have used these kegs on their sides when my kegerator is
Posted in thread: HomeBrewSupply Amcyl Brew Kettle w/ 3-Piece Ball Valve Giveaway! on 07-28-2015 at 02:47 AM
Posted in thread: Gelatin and traveling w a keg on 07-27-2015 at 06:43 PM
If you have the time, I would put the gelatin in this keg and allow to settle for a couple
days. Then rack into another keg to take to the reunion.If you don't have the time or keg
space, just add the...
Posted in thread: Up right keg? on 07-21-2015 at 05:48 PM
Beer is dispensed from the diptube that draws from near the bottom of the keg. Some corny kegs
have the diptube in the center on the bottom, while other corny kegs have it on the side on the
Posted in thread: Coldbreak Brewing Herms Giveaway! on 07-13-2015 at 10:10 PM
Posted in thread: Pin lock kegs........... on 07-10-2015 at 03:41 PM
This thread has the part numbers: you look to the third and fourth pages you will find a
discussion of what has been working for pin lock kegs. Note that the only size difference for
pin locks is on...