VIEW MY

Sparty-On

Gift Premium Subscription To Sparty-On

Join Date:

03-14-2012

Last Activity:

02-22-2013 8:51 PM

    ABOUT ME

  • Phish
  • Single
  • Portland
  • Oregon

LATEST ACTIVITY

  • Posted in thread: New keggle build on 12-06-2012 at 02:41 AM
    Yes definitely use a false bottom in the boil kettle. Hop debris can be a huge problem if not
    cared for the proper way. Also be sure not to place your ball valves above a drainage hole in
    the side of ...

  • Posted in thread: Looking for a welder in NW Indiana or South of Chicago on 06-22-2012 at 03:02 PM
    Post an Ad on Craigslist under "looking for". I posted an Ad looking for a welder and got a
    dozen inquires by the next day. I met a guy who plasma cut two kegs and welded in 6 couplings
    for $100 and s...

  • Posted in thread: WTB Chinchilla Pre-Chiller or the like on 04-24-2012 at 07:03 PM
    Living in Dallas can be wonderful, but with the summer heat fast approaching, my ground water
    will be in the 80's. I need a pre-chiller or I won't be able to get my wort to pitching temp
    despite my ni...

  • Posted in thread: WTB: Keggles on 04-04-2012 at 05:49 PM
    I last contacted him about 6 months ago and he was still doing it.Great. Thanks for the lead.

  • Posted in thread: WTB: Keggles on 04-04-2012 at 04:03 PM
    Adventures in Homebrewing has new ones for $169 with 1 1/2 ch port. They are 199 with 2 ports.I
    did see that. Not a bad deal but after all the hardware installation they come out a little on
    the steep...

  • Posted in thread: WTB: Keggles on 04-04-2012 at 02:37 PM
    Contact this guy Ben. He will cut the tops and weld any fitting you
    want.wisconsinkegs@gmail.comIs he still selling them? I sent an email but I also noticed most
    threads that mentioned him were a coup...

  • Posted in thread: WTB: Keggles on 04-04-2012 at 06:14 AM
    I'm looking for addition keggles in or around Michigan. Preferably two coupling welds.

  • Posted in thread: New SS braid/copper manifold suction design on 03-31-2012 at 03:50 AM
    I'd just abandon the braid and go with a slitted manifold for fly sparging.Is this thee Bobby M
    from youtube?

  • Posted in thread: New SS braid/copper manifold suction design on 03-30-2012 at 07:32 PM
    From what I understand from Palmer's brief fluid dynamic examples, placing the drawpoint at the
    center of the manifold won't necessarily equalize the draw on the whole manifold.In his
    example, having ...

  • Posted in thread: New SS braid/copper manifold suction design on 03-30-2012 at 04:01 AM
    My MLT (60 quart rectangle Coleman) currently uses a SS braid that makes a full loop from a T
    joint coming out of my bulkhead. I'm going to start fly sparging and I've noticed my SS braid
    floating to ...

0 COMMENTS
POST A COMMENT