Last Activity:07-06-2014 10:00 AM
3 Likes on 2 Posts
Posted in thread: Crooked dimple on keg for bushing on 12-11-2013 at 11:30 PM
I have bayou classics so my walls are pretty thin... but i just thread in a fitting(like a
valve) for leverage, then use a bit of force to position the fitting how i need. If you stretch
the hole too ...
Posted in thread: Soldering Stainless steel on 12-11-2013 at 02:13 AM
Some good info the following links also good info on all brazing alloys
Posted in thread: Soldering Stainless steel on 12-10-2013 at 06:29 PM
Gauge of the pot comes into play here too
Posted in thread: Soldering Stainless steel on 12-10-2013 at 03:59 PM
I'd think a propane torch could handle that, might take a while. Propane is common for brazing.
Max flame heat for propane is ~1900 on air. A Map Pro(or similar) torch would be better though,
Posted in thread: Cyber Monday At NIKOBREW! on 12-06-2013 at 11:09 PM
18lbs here :)
Posted in thread: DIY stir plate keeps throwing bar in liquid on 11-06-2013 at 05:57 PM
Try adding a washer under the magnets, set the magnets on it(I stack mine), and glue it all
down. Worked for me
Posted in thread: Bayou Classic Burner - LP to NG on 11-05-2013 at 03:43 AM
Did you get NG orifices?
Posted in thread: Soldering Stainless steel on 11-05-2013 at 02:20 AM
Here's a couple I've done. Turned out great, used PVC coupler, washers, and bolts from stuff I
had laying around. This is actually slightly too big, so i just put a pvc spacer inside the
coupler to ...
Posted in thread: Show us your sculpture or brew rig on 11-04-2013 at 09:43 PM
Nothin' pretty, but works well and was easy to build. We've got 2 identical 62qt Bayou's for
HLT and BK, 1 84qt Bayou for MLT. "Erector set" brewstand; unfortunately I live in a town house
and no long...
Posted in thread: Show Me Your Wood Brew Sculpture/Rig on 11-04-2013 at 09:40 PM
doh, had both open...meant to post to: thanks! >.>