Last Activity:08-02-2015 2:28 PM
2 Likes on 2 Posts
Posted in thread: Super Simple 15G Plastic Conical on 06-20-2012 at 08:29 PM
What about this? ended up buying these based of another guy's build bulkheads look almost
identical to mine... I'm guessing stainlessbrewing gets them from Swagelok. That picture is not
Posted in thread: Super Simple 15G Plastic Conical on 06-20-2012 at 01:10 PM
Here is something I was thinking about with an immersion chiller inside the Ferm tank. I have
25' of copper, which I will switch out once my special order stainless comes in. I used 1/4"
ice maker lin...
Posted in thread: electronic valves on 06-18-2012 at 01:21 PM
They have motorized ball valves at (the commercial site run by the contributors to the
brewtroller project). They are stainless and look pretty nice. $50 a pop. They seem to be out
of stock but that...
Posted in thread: 230 Volt Digital Thermostat / Controller on 06-18-2012 at 01:03 PM
I did manage to scrape together SOME kind of documentation online and I am pretty sure that the
SSR output on the PID IS for activating a SSR rather than acting as an SSR.Yes, the linked pdf
on the pa...
Posted in thread: 55 Gallon AE Kettle system on 06-13-2012 at 01:44 PM
Curious. Which model did you get and where did you get. I haven't had much luck tracking down
prices on the Thomsens on-line.
Posted in thread: Plastic barrel for electric HLT on 05-27-2012 at 10:58 PM
Most of the large HDPE barrels are pretty thick and strong as hell, and can handle mash and
even boil temps without issue. I think some products are even "hot packed" in HDPE. A while
back there was a...
Posted in thread: Plastic barrel for electric HLT on 05-26-2012 at 09:52 PM
no way would i suggest putting 55 gallons of 170 degree water in a plastic container. 456
pounds of water hot enough to fatally burn you isnt something to play with.I appreciate the
safety concerns, b...
Posted in thread: Inductor Tank Regimen on 05-26-2012 at 09:48 PM
Thanks for the info. That's interesting that you screwed to side port ball valve directly into
the tank. I purchased flanges for side that I was going to screw into, but maybe your approach
Posted in thread: Inductor Tank Regimen on 05-25-2012 at 03:37 PM
Hi Budzu,I will be using these inductors commercially as well. I will have 4 60 gallons, two 30
inch and two 24 inch. Would you happen to have any photos of what you did with the lid? Did you
buy an e...
Posted in thread: Plastic barrel for electric HLT on 05-24-2012 at 09:06 PM
What size HDPE container are you planning to use?It's 55 gallon.