Last Activity:02-27-2015 1:37 PM
Likes Given: 175
50 Likes on 40 Posts
Stc controller build
You're racking up the beers. Saved my STC 1000 too. Thank you so much!For future searchers, my
STC-1000 was not lighting up at all, and when I would hit "d" in Arduino, it said that the STC
was not de...
I'm having the same problem. A few seconds into my flash it seemed to disconnect. When I
connected the next time I got the alarm, then a quieter alarm without any display, and now
nothing. I looked fo...
Got some work to do tonight, making the world a better place, one alphaomega equipped stc-1000
at a time
Any interest in a STC-1000 + "PRO Edition"?
I've got some work to do :)
Smithabusa...once again...you're a lifesaver!! Where are you located, I travel a lot for work
and when I'm in your neck of the woods I'm buying you a beer.I think you've saved me twice in
as many week...
STC-1000+ PI (the mash control firmware)
I have a couple of ssr's now, but never used them before, are there commercially available
mounting pads for them etc that anyone is aware of?
Black Pipe Draft Tower
Very nice work!
Keezer in a freezing garage
A dual temp controller (see my signature I have some links to the ones I build) with a 40 or 75
watt light bulb will do the trick. It's been below zero in Michigan for many days in a row and
I would try setting the sketch to auto program versus having to go through the monitor. Then
connect it, and push the reset button