skipper1953

LATEST ACTIVITY

• Posted in thread: Fried my SSR on 05-06-2013 at 10:49 PM
  Not sure how much it would help with the heat issue but, you could use just one SSR to control
  your heating element since that is all that is "required".

• Posted in thread: Auber SYL-2352 and RTD100 probe troubleshooting. on 03-18-2013 at 01:33 AM
  Section 4.7 of the operating instructions says that you need to set parameter "Sn" to 21.

• Posted in thread: OK to plug carboy when crash cooling? on 02-23-2013 at 02:06 AM
  Get yourself a nice clean handkerchief. Fold it in half then half again. Lay it over the top of
  the carboy and secure it with a rubberband or a nice piece of string. The only thing that will
  likely ge...

• Posted in thread: bubbles in my herms line on 02-16-2013 at 05:31 PM
  The only thing I can think of is that the grain bed is getting compressed and isn't letting
  enough wort through. But I'm still confused as to how the air bubbles are getting in the line.
  if the grain ...

• Posted in thread: HomeBrewTalk 2013 Big Giveaway! on 02-09-2013 at 12:15 AM
  Reply

• Posted in thread: Solenoid Valve on Beer Line on 01-28-2013 at 12:56 AM
  Sorry to revive an old thread, but how about using these and just converting down the pipe
  thread: Those valves have an awfully low pressure rating. Normal serving pressures for a keg
  would likely r...

• Posted in thread: Malt Conditioning the EASY WAY!! on 12-31-2012 at 02:58 AM
  Does conditioning malt make for less flour? Or is it only husks that are protected? The reason
  I ask is I Brew in a Bag, and don't care about the husk being intact for sparging. But less
  flour would i...

• Posted in thread: Finned heat exchange tubing for a counterflow chiller? on 12-30-2012 at 11:42 PM
  I tried it. The piece of 4" sched. 80 PVC I used is back to serving as a rain spout extension.
  I couldn't make it work well enough for it to be of any use. I only played around with it for a
  couple of...

• Posted in thread: One contactor for two elements? on 12-24-2012 at 02:37 PM
  When you are finished mashing, just unplug the MLT or the HLT and plug in the BK in its place.
  You still have contactors controlling the elements and a dedicated main power contactor.

• Posted in thread: Deep Wood Brew - Grand Opening Giveaway! on 12-24-2012 at 12:34 PM
  And the winner is...