Last Activity:03-04-2014 3:30 PM
Likes Given: 11
15 Likes on 10 Posts
Posted in thread: Electrician Help Needed (Charlotte NC) on 02-22-2014 at 02:30 PM
Help needed wiring control panel to brew stand. Panel has been made, all I need to have done is
the wiring. Will compensate accordingly. Thanks!!
Posted in thread: HomeBrewTalk 2014 Big Giveaway on 02-22-2014 at 02:27 PM
count me in! awesome!!!
Posted in thread: Small Grain Bills on 01-16-2014 at 10:30 PM
:rockin: I have been brewing a lot of session beers lately and have had to really watch to make
sure I dont over sparge and run below 1.010. Is there a threshold of how small a grain bill can
Posted in thread: Spike Brewing 12.5 Gallon Conical Fermenter Giveaway! on 01-08-2014 at 10:47 AM
count me in! Thanks!!!!
Posted in thread: Tits-Up Imperial IPA (3-Time Medalist - 2 Golds, 1 Silver) on 12-05-2013 at 04:45 PM
gonna brew this up next to try to deplete some of my hops i have in storage. Had to substitute
a few hops. I used beer smith to make sure all the ibus stayed the same. Do these look like ok
Posted in thread: 120V to 24V Transformer Blew on 12-05-2013 at 04:05 AM
so to do that I would run the a wire from the 24v side of the transformer into T10 and from T11
to on side of the gas valve? would a 1A fuse be sufficient if I did it that route?
Posted in thread: 120V to 24V Transformer Blew on 12-04-2013 at 05:10 PM
I'm wondering now if I have my controller wired correctly as well? I have seen diagrams that
have the transformer being wired directly from the hot bus, with one lead then going to the gas
valve and o...
Posted in thread: 120V to 24V Transformer Blew on 12-04-2013 at 04:43 PM
I assume the wire on T11 of the controller should be red (hot)? Is that a 24V AC xfmr wired to
24AC valves? What is the amp rating of the xmfr and your valves? Both wires from the xmfr go to
Posted in thread: 120V to 24V Transformer Blew on 11-24-2013 at 06:01 AM
Posted in thread: Show us your Top Tier configuration on 11-24-2013 at 06:00 AM