Last Activity:04-24-2016 3:31 PM
1 Likes on 1 Posts
Posted in thread: Real Stir Plate Coil Magnet on 11-30-2015 at 04:22 AM
I like the idea of a solid state stir plate. You can probably use a stepper motor controller to
get it to work. They are common and you can find them pretty cheap.
Posted in thread: Is My Starter Ready? on 11-30-2012 at 03:27 PM
You'll be fine. The extra water will just lower the gravity of your starter. This is better
than having a gravity over 1.040. Since you plan on decanting, you won't thin your wort out
either. As far a...
Posted in thread: Yeast on 10-07-2012 at 05:22 PM
I'd buy it. Make a starter though.
Posted in thread: Just a little experiment... on 09-18-2012 at 12:19 AM
How will you know if it worked? I guess if a refractometer and hydrometer read the same, you
could be somewhat certain it worked. No alcohol to skew the refractometer reading.
Posted in thread: Tell me about your brew rig on 09-02-2012 at 10:37 PM
I built my rig but I have a little input. You can buy a 1 bbl 4 vessel system from stout tanks
in Portland for $3100. I'm sure you could get a half bbl system for $2500 or less. That
includes a conica...
Posted in thread: The Beer Lovers Escape on 08-31-2012 at 05:15 PM
I like the "made from beer" line at the end. That's awesome.
Posted in thread: Too late to make a starter? on 08-31-2012 at 05:08 PM
You don't have to pitch right away. You could still use the stir plate for both batches. You
could even do a real wort starter with the second batch and pitch the whole starter without
Posted in thread: Can you measure the gravity of beer after conditioned? on 08-31-2012 at 04:07 PM
You don't even need the OG if you have a refractometer, hydrometer and beer smith. Degas a
bottle, take a reading with both the refractometer and hydrometer and beer smith will give you
the OG and ABV...
Posted in thread: Simple slow flash circuit?? on 08-27-2012 at 04:50 AM
I like it! :)Now, how about simulating how big a cap he'd need to stick on Q1's emitter to make
the on/off transition slew rate slow enough to providing a noticeable fade-in/fade-off effect?
Posted in thread: Simple slow flash circuit?? on 08-26-2012 at 06:44 PM
Instead of a trimmer cap, I'd just go with a trim pot. You can get everything in your circuit
at radio shack or fry's electronics for pretty cheap. Just put a 10k resistor in series with
your trim pot...