sdugre

Gift Premium Subscription To sdugre

Join Date:

01-04-2011

Last Activity:

07-02-2014 7:59 PM

    ABOUT ME

  • Single
  • Holyoke
  • MA

LATEST ACTIVITY

  • Posted in thread: grassy 2013 Amarillo hops on 02-17-2014 at 07:34 PM
    Wish I would have seen this thread before I blew through 6 oz in an IPA. Mine seems worse than
    grassy. Super vegetal with an almost pumpkin flesh flavor. Do you think these would be OK to
    bitter with ...

  • Posted in thread: Kettle Junction Box on 08-01-2012 at 10:00 PM
    Check out this post:

  • Posted in thread: Switch element from 240v to 120v on 07-20-2012 at 08:42 PM
    Check out Quaffer's schematic: RE4 is a single pole double throw relay which selects between a
    hot leg and neutral depending on the position of the "rims power switch". For your application,
    you coul...

  • Posted in thread: Aubers Contactor on 06-16-2012 at 11:04 PM
    The polarity doesn't matter. Bring your hot to one side and neutral to the other.

  • Posted in thread: Another ammature question on 06-13-2012 at 12:28 AM
    For my HLT, I use the PID alarm to protect against a failed SSR. The alarm contact is in series
    with the coil of the contactor and is set to drop out if the temperature goes above 180F.

  • Posted in thread: Power circuit design idea on 06-04-2012 at 10:33 PM
    It looks to me like your design would work, however you could accomplish the same thing with
    two DPST relays, one for each element. Just wire your element selector switch to switch the hot
    to the appr...

  • Posted in thread: The numbers don't add up again...WHY?!? on 05-12-2012 at 01:39 PM
    no CFC for me. Just an immersion chiller Do you put the immersion chiller in the kettle during
    the boil (after the pre boil reading is taken) ? That could make your post boil volume reading
    look high...

  • Posted in thread: 3-Phase Power Questions on 05-10-2012 at 09:38 PM
    That's correct. With pumps, you're probably looking at about 28.5 amps.As far as what's "right"
    with regards to upgrading, I'm sure you'll get opinions on both sides of the coin. I'm
    personally in the...

  • Posted in thread: The numbers don't add up again...WHY?!? on 05-09-2012 at 09:48 PM
    I'm wondering if it doesn't have something to do with temperature and expansion under
    temperature. Not sure about beersmith, but in beertools, pre boil volume is shown @ 212. If
    beerstools tells me I ...

  • Posted in thread: 3-Phase Power Questions on 05-09-2012 at 09:05 PM
    If you want 5500 watts, replace the element with one rated at 208V. Here's an example:

0 COMMENTS
POST A COMMENT