sco999

Gift Premium Subscription To sco999

Join Date:

09-09-2010

Last Activity:

05-29-2012 2:09 PM

    ABOUT ME

  • North of Nowhere
  • Single

LATEST ACTIVITY

  • Posted in thread: 17th Annual SSBC Homebrew Competition on 04-30-2012 at 01:17 AM
    any idea what beer took 1st overall?

  • Posted in thread: 17th Annual SSBC Homebrew Competition on 04-29-2012 at 10:08 PM
    Were they able to finish the Judging today?

  • Posted in thread: 17th Annual SSBC Homebrew Competition on 04-23-2012 at 05:46 PM
    Any idea when the results will be posted?

  • Posted in thread: Electric Question on 03-28-2011 at 08:35 PM
    Ohio-Ed, What size wires are the blue, red, and purple wires that are sending signals between
    the ssr's and the switches/bcs? Thanks

  • Posted in thread: Advise on 1st water treatment on 02-10-2011 at 05:41 PM
    Thank You so much.I think I am going to go with 75% RO Water, and 2% acid malt.How does this
    look for an American IPA with some assertive hop quality?Starting Water
    (ppm):Ca:49Mg:17Na:20Cl:26SO4:33CaC...

  • Posted in thread: Advise on 1st water treatment on 02-09-2011 at 10:25 PM
    I could use some input on my water.I am looking at adjusting my water for an American IPA. I am
    a little confused about what SRM value to use. I am adding 1/2 lb of carafa III for the last
    15min of th...

  • Posted in thread: ESB Not Carbonating on 02-07-2011 at 06:20 PM
    Did you overfill? I also will suggest shaking or rolling the keg. The first beer I kegged was
    flat after 40hours @30psi then 1 week @12psi temp was 39F. I shook the keg for a few minutes
    then it carbe...

  • Posted in thread: Using therminator for the first time questions about pump on 02-02-2011 at 05:45 PM
    Kettle Drain Valve -> Pump -> Therminator -> FermenterWatch out for hop debris.

  • Posted in thread: All Grain Equipment. on 02-02-2011 at 01:17 AM
    Equipment sold locally.

  • Posted in thread: What RPM do you run your grain mill at? on 02-01-2011 at 06:18 PM
    I run my Barley Crusher @ 400 rpm. no problems yet.

0 COMMENTS
POST A COMMENT