VIEW MY

schrod

Gift Premium Subscription To schrod

Join Date:

10-18-2009

Last Activity:

01-24-2017 3:03 AM

3 Likes on 2 Posts 

    ABOUT ME

  • CT
  • Software Engineer
  • Male
  • Married

LATEST ACTIVITY

  • Posted in thread: CraftBeerPi - Raspberry Pi Software on 01-10-2017 at 09:18 PM
    Thanks! I was just reading this on the GitHub site. I can't wait to try it out. I may try it
    with a water boil tonight.So, it will go to a set temp and then kick into the duty cycle? Or
    will it start ...

  • Posted in thread: CraftBeerPi - Raspberry Pi Software on 01-10-2017 at 01:31 PM
    Care to explain a bit more? Where do i need to hook the heater up to?You would hook the heater
    up to a GIO through an SSR, the same as if you were going to use PID control. Then under Kettle
    Configura...

  • Posted in thread: CraftBeerPi - Raspberry Pi Software on 01-10-2017 at 03:48 AM
    PWM was a feature I was also wishing for, and lacking the excuse of not being a programmer, I
    took a stab at adding it. I ended up creating a new "automatic" called PWM that lets you
    specify a period ...

  • Posted in thread: STC-1000 Broken Terminal on 11-18-2013 at 07:39 PM
    It'll probably be marginally easier to reattach the terminals. It would take more heat to heat
    the wire than just the terminal. If you don't heat it right you'll be right back where you
    started with a...

  • Posted in thread: STC-1000 Broken Terminal on 11-18-2013 at 06:26 PM
    Did the board break, or did the screw terminals pull out of the solder? The solder/process they
    use isn't very good. When I built mine I had the terminals pull out of the board. I was able to
    re-solde...

  • Posted in thread: Power Connectors 30 amps on 10-13-2013 at 09:41 PM
    @schrod I have Anderson SB series connectors on a battery charger but they are only 2 pole.
    Which ones are you using exactly?I'm using the PP45 contacts. They slide together so you can
    build up whatev...

  • Posted in thread: Power Connectors 30 amps on 10-13-2013 at 02:36 PM
    I haven't seen them mentioned on this site before, but I used Anderson Power Pole connectors.
    They aren't water proof if that's a concern for you. My control box isn't either so I wasn't
    worried about...

  • Posted in thread: eBrewSupply - Electric Brewing Hardware Opening Soon on 05-03-2012 at 04:17 PM
    I'll take a coupon. Thanks!

  • Posted in thread: CT Group Grain Buy on 06-28-2011 at 08:56 PM
    I'd also be interested if this happens again.

  • Posted in thread: Timer to control temps in a fridge? on 06-08-2011 at 07:15 PM
    To beat the dead horse, I've attached a plot of the temperatures in my fridge. There is a 5
    gallon batch in there now that is going on 5 days. You can see that slight change in ambient
    temperature has...

0 COMMENTS
POST A COMMENT