Last Activity:04-23-2014 12:46 AM
1 Likes on 1 Posts
Posted in thread: Shiner Ruby Redbird Clone Recipe on 04-20-2014 at 11:07 PM
Just had this years batch. I think it's even better than last year's. It is a bit more balanced
(I thought last year's was heavy on the ginger.)
Posted in thread: How to build a 5 gal, 110v eBIAB kettle on 07-26-2013 at 10:38 PM
How effective is soldering the ground wire to an aluminum pot?For my grounds, I tried to squish
the wires underneath the washer, then soldered it and then covered it in epoxy to protect the
Posted in thread: Step by Step build a 110v portable PID controller on 06-22-2013 at 02:25 PM
I would just like to add after a few months: Don't scrimp out and buy the cheaper PID off of
Amazon like me. Buy the Auber. The Amazon one is a POS.
Posted in thread: Kegerator Conversion with Danby DAR440BL? on 04-29-2013 at 03:13 AM
I just used a utility knife with a sharp blade. Cut them right out no problems.Seconding
this.If you're having a tough time on parts, I found it easy to score the plastic lightly then
do a full blade ...
Posted in thread: DIY Bucket Filters on 04-28-2013 at 03:17 PM
What size (microns) do you need?
Posted in thread: How many gallons of BierMuncher's Centennial Blonde have been brewed? on 04-17-2013 at 02:53 AM
3980+5 = 3985My first batch and first all grain batch just last week!:mug:
Posted in thread: Step by Step build a 110v portable PID controller on 04-14-2013 at 03:16 PM
Would that controller work for controlling a boil?I only use it to control the mash. To boil, I
unplug the PID, plug both elements directly into the wall and let them go at it full blast.
Gives me a r...
Posted in thread: Temp control... for dummy (that's me) on 04-12-2013 at 03:18 AM
I built my controller using These directions. It was pretty easy and worked great.I used
cheaper components from Amazon instead of the Auber ones though.
Posted in thread: Dummies Guide to DAR440BL Tower Conversion on 04-04-2013 at 09:41 PM
Hey all. I recently finished up most of the construction on my DAR440BL dual tower kegerator. I
just wanted to give a few pointers on how to make it super easy for any of you wanting a tower
Posted in thread: About to take saw to the Danby, is there a better way? on 04-04-2013 at 05:23 AM
I used a box cutter/xacto knife to cut out the extended shelving parts. Then the flat white
backing just peeled off. Took maybe 20 minutes. Pretty easy.