Gift Premium Subscription To sasky7777

Join Date:


Last Activity:

11-22-2015 6:12 PM

Likes Given: 15

13 Likes on 11 Posts 


  • Posted in thread: Ss Brewtech’s Biggest Baddest Holiday Giveaway Ever! on 11-20-2015 at 06:11 PM

  • Posted in thread: Sanity Check on Kal clones on 10-06-2015 at 10:02 PM
    307930spoke to one of the maintenance guys at work. He agreed that the neutrals shouldn't be an
    issue. He also let me use his crimper, this should get the job done.

  • Posted in thread: Tan, non grapefruit-ie IIPA recipe? on 09-30-2015 at 03:12 AM
    What about Sorachi Ace, or Motueka or Southern Cross? I would also cut the Carapils and add
    more 2 row.

  • Posted in thread: Sanity Check on Kal clones on 09-28-2015 at 10:27 PM
    My thinking on the neutrals is that in the instructions he states "As mentioned in the previous
    bullet, if the component you wish to connect to a bus is close to another component that is
    already conn...

  • Posted in thread: Sanity Check on Kal clones on 09-28-2015 at 08:56 PM
    I will probably have more issues but I had two questions right now. In his wiring plans the
    neutral comes from the main power in to the neutral bus as seen below. 306276Is there any issue
    in putting m...

  • Posted in thread: HERMS help - compression fitting doesn't fit! on 09-28-2015 at 05:52 PM
    On a side note, I have bought from Bobby a few times, and have never had border issues. 90% of
    my brewery came from the US and I never had issues.

  • Posted in thread: Has anyone tried growing their own barley? on 09-13-2015 at 04:35 PM
    2 row malt. Our "patch" is a bit bigger. 303008

  • Posted in thread: Speidel fermentors - now with stainless rotating racking arm! on 09-13-2015 at 04:29 PM
    I used a step bit, and turned it by hand since the plastic is so soft. I drilled a small pilot
    hole then used the step bit checking at each step to test fit, I think it was 1/2, but the step
    bit worke...

  • Posted in thread: Stc-1000+ on 08-05-2015 at 09:07 PM
    Last follow up to the flashing, I found it much easier not to remove the solder from the STC
    board and just press the pins from the Arduino to it. I got the best connection on the bottom
    of the STC, a...

  • Posted in thread: Stc-1000+ on 08-04-2015 at 04:11 PM
    I didn't take out any pins and just hooked it up. I can't solder electronics worth a damn but
    somehow got enough in there and didn't fry the board. My biggest issue was drivers. I couldn't
    get Arduino...


Newest Threads