Last Activity:12-03-2012 10:04 AM
Posted in thread: Help selecting a ph meter on 12-03-2012 at 02:58 PM
Posted in thread: Help selecting a ph meter on 11-27-2012 at 05:19 PM
I am looking a hydrofarm hmdph200 meter. Does anyone currently use one and what are your
thoughts on one? I have seen good reviews on here about a Hanna model but not on this one even
though this one ...
Posted in thread: using juniper berries on 05-22-2011 at 12:00 PM
I am visiting some family in the southwest now and I am thinking about make a batch of beer
with some local ingredients ... juniper berries and mesquite when I get home. My question is do
you pick the...
Posted in thread: Southern Il. brew club on 05-15-2011 at 09:33 PM
Back in October I found some people with the same idea, they were farther along than I was in
setting one up so I just went with them. We have quite a few members now. You can check out our
Posted in thread: Smack pack sprung a leak on 04-27-2011 at 03:06 AM
This happened when I was trying to break the inter pouch so I can make a starter tonight; it is
just a pin hole leak. I swabbed it with alcohol. Has anyone else had this happen? And should I
Posted in thread: What would you do? on 03-30-2011 at 09:17 PM
Here is the story: I have a batch of scwartzbier in my fermentation chamber in the D-rest phase
of fermentation (so my temp is set to 60 F). I really want to brew a batch of hefeweizen
Posted in thread: My E-HERMS build pix on 03-26-2011 at 03:45 PM
Are you going to agitate your hlt water? I found I needed to in my herms setup. Also, at 1gpm,
I think you will get about a 1 degree temp rise per minute. At least that is what i have seen
in most set...
Posted in thread: Golf Cart Kegerator on 03-25-2011 at 08:51 PM
I force carb and no matter how good I am at leaving the sediment behind in the primary I still
always end up with a little sediment in the bottom of my kegs when I empty one. But neat idea!
Just hope ...
Posted in thread: keggle cut to small on 03-25-2011 at 07:21 PM
Hey James it's Sam from SIB, When I did mine (my keggles was cut closer to what I wanted) but I
had to smooth out the rough edges and take some off so my lid could fit, but this is what I
did: I used...