Gift Premium Subscription To sam

Join Date:


Last Activity:

02-18-2017 11:08 PM

Referrals: 3

Likes Given: 16

27 Likes on 16 Posts 


  • Bridgewater, NJ
  • ALEiens Homebrew Club
  • Male
  • Married


  • Posted in thread: Sam's Brew Box on 11-15-2016 at 04:01 PM
    I had a problem with my SYL-2802... the temp readings were jumping around. After sending Auber
    a video they quickly diagnosed the issue as power line noise/interference and sent me a
    replacement unit ...

  • Posted in thread: Where do you get a Control Panel Nameplate? on 11-07-2016 at 03:36 PM
    I like Mine is on their largest stock because it covers my entire panel; cost about
    $40 shipped (with a $20 off first order promotion). A smaller nameplate would be cheaper.
    color filling...

  • Posted in thread: Show us your panel on 11-06-2016 at 03:54 PM
    About a year ago I was inspired by this thread to upgrade to electric. It's been a long road
    but I finally finished today and felt it was time to post here.Thanks to everyone for the
    inspiration and a...

  • Posted in thread: Sam's Brew Box on 11-06-2016 at 03:29 PM
    Finished! I still need mark volumes on my sight glasses but, other than that, I think all I
    have left to do is brew. all my tubing... notice on my panel that I don't use a PID for the
    MLT. Instead, ...

  • Posted in thread: Sam's Brew Box on 11-02-2016 at 06:29 PM
    I'm getting close... did some tests with just water.The 50 feet of herms coil definitely slows
    the flow down quite a bit. The mini ball valves I have are not full port and don't help but I
    really like...

  • Posted in thread: Sam's Brew Box on 11-02-2016 at 02:24 AM
    Oh, and by the way... pulling 6-gauge wire through 3/4 inch conduit is not easy.

  • Posted in thread: Sam's Brew Box on 11-02-2016 at 02:20 AM
    I've been debating over where/how to mount the box. The wall probably would have been easiest
    but, when I was picking up the conduit for the outlet, I noticed the unistrut in the same
    aisle. Since my ...

  • Posted in thread: Sam's Brew Box on 11-02-2016 at 02:02 AM
    haha, thanks! I wonder how many g-forces those little electrons pull as they round the corners
    at that speed...That's some clean wiring!You do know sharp 90 degree bends slows the
    electricity down, ri...

  • Posted in thread: Getting excited again... on 11-02-2016 at 01:52 AM
    Looks great! :mug:

  • Posted in thread: Sam's Brew Box on 10-26-2016 at 03:53 AM