VIEW MY

sabo38

Gift Premium Subscription To sabo38

Join Date:

01-23-2013

Last Activity:

08-25-2016 1:25 PM

Likes Given: 4

10 Likes on 9 Posts 

LATEST ACTIVITY

  • Posted in thread: Colorado brewing systems on 08-10-2016 at 07:13 PM
    .045" is what I have mine set at. I usually run my pump around 1/2 depending on how everything
    is flowing. I have not used rice hulls yet but I think I will in the future so I can
    recirculate a little...

  • Posted in thread: Unboxing the Nano from CO Brewing on 08-08-2016 at 12:13 AM
    He already emailed me back. It's covered under warranty so we'll see if the 2nd one holds up
    better than the 1st.

  • Posted in thread: Unboxing the Nano from CO Brewing on 08-07-2016 at 03:30 PM
    It died altogether. I plugged it in this morning just to make sure and it's dead. Had to deuce
    over to my regular pump during cool down was not easy either. I had no shutoff between the pump
    and my ke...

  • Posted in thread: Unboxing the Nano from CO Brewing on 08-06-2016 at 08:10 PM
    So that little brushless pump that they sent us is a total POS. I've used it for less than an
    hour and it's already fried. I was sending my wort through my chiller and all of a sudden it
    just stopped ...

  • Posted in thread: Unboxing the Nano from CO Brewing on 08-03-2016 at 12:23 AM
    364765This is the whirlpool fitting that goes in the whirlpool port on the bottom.

  • Posted in thread: Unboxing the Nano from CO Brewing on 08-03-2016 at 12:22 AM
    364764Is this what your looking for?

  • Posted in thread: Unboxing the Nano from CO Brewing on 08-01-2016 at 12:18 AM
    So do you add 3 degrees to your mash temp? I would think if you were off at the top you would
    probably be off at mash temp.

  • Posted in thread: Unboxing the Nano from CO Brewing on 07-31-2016 at 11:16 PM
    Mine should be 212. My grain bed temp and PID are about 3 degrees different so I think if I
    would bump it up 3 degrees I would be pretty close to mash temp.

  • Posted in thread: Unboxing the Nano from CO Brewing on 07-31-2016 at 12:24 AM
    Where do you find how to calibrate temp? My PID shows 209 at boiling and I need to add 3
    degrees to it.

  • Posted in thread: Unboxing the Nano from CO Brewing on 07-29-2016 at 03:09 PM
    Doing an Oktoberfest Ale this weekend, did an Irish Red last weekend, everything went very
    good. I just needed to watch/adjust the pump output to make sure I didn't suck the bottom of
    the pot dry. Onc...

0 COMMENTS
POST A COMMENT