Last Activity:06-20-2011 2:50 AM
Posted in thread: first time kegging, i got some questions... on 04-18-2010 at 05:56 PM
Regarding my "inferior product" comment earlier, if you rush your carbonation by shaking,
rolling, or just setting the pressure super high, you will get a harsh carbonic acid bite. It
goes away after ...
Posted in thread: first time kegging, i got some questions... on 04-18-2010 at 05:46 PM
To keep your beer properly carbonated you need to keep your gas hooked up to your keg at the
same psi for serving. If you have foaming at that pressure that is most likely a line lenth
issue.See link ...
Posted in thread: first time kegging, i got some questions... on 04-18-2010 at 06:59 AM
If you follow this carbonation table you will never go wrong. It is physically impossible to
over carbonate a beer if you set the pressure according to your serving temperature. +1FWIW, I
Posted in thread: first time kegging, i got some questions... on 04-18-2010 at 05:51 AM
Don't boost carb unless you absolutely must have it carbed immediately. It makes for an
inferior beer and is easy to overcarb, then you spend days trying to balance it again. Just set
it to serving pr...
Posted in thread: Beer Concentrate? on 03-02-2010 at 03:56 AM
Have you seen this? a backpacker and hope this stuff is the real deal..
Posted in thread: Growlers on 02-21-2010 at 06:03 PM
I get corny kegs filled, straight from their serving tank in their cold room.
Posted in thread: Which beer related websites do you check regularly? on 02-04-2010 at 05:31 AM
Homebrewtalk.comMorebeer forumNorthernbrewer forumThe Brewing Network..... just a few of
mine.How about you?
Posted in thread: Brass propane orifice to hard pipe connection? on 02-03-2010 at 04:50 PM
oh, i didnt read your previous post carefully enough. The fit wasnt great, but it worked. I
just teflon taped and forced it in. Its not like the entire pressure of the gas line is on that
seal, so i w...
Posted in thread: Brass propane orifice to hard pipe connection? on 02-03-2010 at 04:34 PM
Not sure if this is what you need.. but I used this piece to connect from my burner to black
pipe via a brass 3/8 to 1/2 in reducer