Last Activity:07-04-2014 12:34 PM
Posted in thread: Lp Gas, Honeywell Valves, & Auber Temp Control Questions on 04-06-2012 at 05:07 PM
I just built pretty much this exact setup, so I guess I can chime in. I went with the 2342's
with RTDs. Right now they're running in on/off mode per the basic instructions in the manual. I
tried one o...
Posted in thread: 2 timers in control panel? on 03-29-2012 at 07:53 PM
I used 2 ASL-51s on my Kal-panel. I'm gas fired with manual control on the BK so had the extra
hole to fill.I set one timer for long processes like total mash or boil duration. Then the
second one is ...
Posted in thread: Mounting Bolt size for Banjo Burner on 11-03-2011 at 02:25 PM
Metric M6 IIRC. I was just going through this the other week. This is assuming they all come
from the same factory and are all threaded to the same spec.FWIW, the big box hardware stores
(near me anyw...
Posted in thread: Tri clover sight glass on 09-02-2011 at 12:37 PM
Posted in thread: Weldless brew stand. on 07-25-2011 at 11:06 PM
Why did you decide to convert them to low pressure, what's the benefit?Thanks and good luck on
your buildI was planning on direct firing the MT, so some finer control there. Supposedly
Posted in thread: Weldless brew stand. on 07-23-2011 at 12:44 PM
I am thinking that I will use 2 of these burners, 1 for the HLT and 1 for the BK. than that
I'm not sure exactly what else must be ordered. I saw some people say they don't come with a
jet, etc.I ju...
Posted in thread: storing star san in a corney on 11-10-2009 at 02:02 AM
I'm no chemist, but it comes UNdiluted in a regular hpde #2 container. It doesn't eat it's way
through that. I don't see how there's much chance of it destroying an hpde fermenter bucket or
Posted in thread: Question about the National Homebrew Competition on 11-04-2009 at 07:41 PM
Yeah, the competition registration doesn't start until Feb/Mar. Here's the link to the
competition page on the new site:
Posted in thread: Tips for nitro tap? on 10-16-2009 at 10:58 PM
I've just gone through the first keg on my nitro faucet. I think you'll do fine to set and
forget. I carbonated with co2 the same you would any other beer. Seal the lid with ~20psi and
then carbonate ...
Posted in thread: 8 mm Spouts on 08-03-2009 at 02:15 PM
A few observations after a weekend of "testing".On low-normal carbonation beers the pour is
much nicer. No more air bubble trapped at the spout. The air bubble seemed to cause some extra