Last Activity:08-16-2013 9:18 PM
Posted in thread: Home Bar Design on 08-17-2013 at 03:17 AM
My bar has the keezer on the back side of the wall. I put a decent size blower to circulate air
around the lines so I don't get foam any more. Computer fans didn't cut it.
Posted in thread: No refrigerant? on 07-20-2013 at 12:58 AM
Same thing happened on my first keezer build.Compressor would run non stop and never cool.
Posted in thread: Finished my keezer just to scrap it on 06-29-2013 at 05:47 PM
I had a chest freezer sitting in my basement that I bought about 6 years ago. It had sat idle
for two years. I learned a very common sense lesson on this one. I plugged it prior to the
conversion and ...
Posted in thread: Kegerator Conversion with Danby DAR440BL? on 04-25-2013 at 02:20 PM
What attachment did you use to cut out the shelf supports?I just used a utility knife with a
sharp blade. Cut them right out no problems.
Posted in thread: Kegerator Conversion with Danby DAR440BL? on 04-03-2013 at 04:00 PM
I am about to build a keezer to replace my Danby kegerator. I would be willing to let the Danby
go cheap. It has two holes drilled in it to recirculate air for a remote faucet.Chris
Posted in thread: Keezer/ tap wall setup?! on 02-06-2013 at 05:23 PM
I have a 3 foot run using 3" PVC wrapped in insulation. I have two beer lines running through
the PVC and circulate cold air with a computer fan. It is not enough to eliminate foam on the
first pour. ...
Posted in thread: Keezer/ tap wall setup?! on 01-14-2013 at 12:09 AM
I have a similar setup with about a 3' line. I am not able to keep the beer lines or the taps
cold circulating air through PVC with a fan.First half pint is foam then fine after that. Wait
10 minutes ...
Posted in thread: Keezer in Basement, Taps Upstairs? Possible? on 12-31-2012 at 08:03 PM
Great thread. I have a 3' run and always have to poor a third of a pint out every beer except
back to back pours.I have a 2" PVC loop with a fan and it doesn't work well enough. I have been
Posted in thread: Kegerator Conversion with Danby DAR440BL? on 12-21-2012 at 02:26 PM
Just a fridge.
Posted in thread: Kegerator Conversion with Danby DAR440BL? on 11-28-2012 at 01:27 PM
Mine in down in the basement, but I haven't noticed it being very loud when around it.