VIEW MY

rourky80

Gift Premium Subscription To rourky80

Join Date:

01-11-2011

Last Activity:

08-04-2015 12:10 PM

5 Likes on 4 Posts 

    ABOUT ME

  • Male
  • Married
  • Albany
  • New York

LATEST ACTIVITY

  • Posted in thread: Creative DIY people, I need your brainpower on 02-26-2015 at 12:34 AM
    ..

  • Posted in thread: Upgrade from SSVR to PID + SSVR on 01-12-2014 at 02:20 PM
    I think the ssr and ssvr in serial would work, and they then are both working and you could run
    it as you intend. For a couple of reasons, one of which i don't have a really valid reason for
    is that I...

  • Posted in thread: Upgrade from SSVR to PID + SSVR on 01-12-2014 at 03:50 AM
    I am looking at having the hot "line 2" that comes into my system and usually only feeds the in
    switching side of the ssr, come in to a dpst selector switch which then feeds the in switching
    side of t...

  • Posted in thread: A Kiwi Keezer! on 01-11-2014 at 11:55 PM
    That's a clothes dryer....... Aus/nz are similar

  • Posted in thread: Upgrade from SSVR to PID + SSVR on 01-11-2014 at 04:17 PM
    I was looking at the same idea for my controller and setup....... I have decided to add a
    selector switch to control either PID or pot (into ssr or ssvr), that way I don't need to go
    into any pid sett...

  • Posted in thread: My Beer dispensing using a soda machine.... on 11-27-2013 at 08:37 PM
    Mine is still working like a charm. The ice bank control on mine is gone too, never worked
    since I had it so I have a timer on the outlet that turns it on either 30-45 mins a day
    depending on the seas...

  • Posted in thread: My Beer dispensing using a soda machine.... on 08-17-2013 at 11:57 PM
    I may have to pull apart one of my taps and pull that piece out and see how good it works, I
    will still need to keep the pressure near 22-24psi due to the temp of the kegs based on the
    pressure graph ...

  • Posted in thread: My Beer dispensing using a soda machine.... on 08-17-2013 at 01:51 PM
    I have the flow restriction all the way out, and my pressures are similar to that, my pours are
    probably slower than a usual tap, but I get nice pours with a good head, so I'm not too worried
    if it ta...

  • Posted in thread: Keg to ekeggle conversion pics on 06-05-2013 at 01:08 AM
    Do you think it's necessary to mount the heat sink outside the toolbox? I was looking at
    mounting it inside cause there would be affair amount of air space, but there is no circulation
    and I'm not sur...

  • Posted in thread: Keg to ekeggle conversion pics on 05-30-2013 at 12:29 AM
    Excellent, thanks so much, those were the ideas I was thinking too, hinges and rubber feet so
    the toolbox isn't sitting on the screws. I have been looking at all kinds of control box
    options, but the ...

0 COMMENTS
POST A COMMENT

Newest Threads

LATEST SPONSOR DEALS