Last Activity:04-28-2016 6:31 PM
Likes Given: 34
12 Likes on 9 Posts
Posted in thread: Homebrew Supply Keg System Giveaway on 03-02-2016 at 06:37 PM
Thanks for doing this giveaway!SkeezerPleezer's Three Floyds Zombie Dust Clone - All-Grain
Posted in thread: Arduino Based Brew Controller on 12-04-2015 at 07:05 PM
I'm in a similar spot as you having half started this project once for an espresso machine, and
again for rims a year or so again. Did you look into any of the open source projects that
already do thi...
Posted in thread: Anyone getting (got) a Synek? on 12-04-2015 at 07:02 PM
I filled bag with CO2 at Med, refilled it next day because it had absorbed some into beer. It
was a bit squishy again today, but I went ahead and attached the back to the machine...It
sounds like you...
Posted in thread: Small n Automated on 12-04-2015 at 06:46 PM
I'm surprised no one has mentioned the picobrew pico. It brews 5L batches, and it's fully
automated up until the chill (unless you no-chill I
Posted in thread: picobrew zymatic questions on 12-04-2015 at 06:30 PM
I think that the grainfather has a nice product but it requires more involvement than the
zymatic. How much time & interest you can have with your brew should determine your choice.
From what I read t...
Posted in thread: Beer Smith or Beer Friend?? on 12-03-2015 at 11:25 PM
I've never used brewers friend, but I don't regret buying beersmith one bit. It has so many
features that I don't use yet - I've got a lot of room to grow before I even utilize it fully.
Posted in thread: Help modifying a 12 point 13/16" socket for pin lock keg on 12-03-2015 at 11:22 PM
I ended up putting the socket on the best I could and marked the location of the pins with a
sharpie. Then used a cutoff wheel in my Dremel to cut the slots. Checking fit as often as I
could.I did th...
Posted in thread: Low BTUs- pump pure O2 into the burner?? on 12-03-2015 at 11:02 PM
I think we've already beaten this subject dead - I'd only add that the o2 cost would quickly
add up to the price of a nicer propane burner. Consider just getting one with more btus or
shielding it bet...
Posted in thread: Can I get some feedback on a RIMS Build? on 12-03-2015 at 10:59 PM
If you aren't looking to spend a ton of coin then you could focus on simply hitting your
initial mash temp better. I used an anova sous vide machine (shaped like an immersion blender)
on my last brew ...
Posted in thread: Wifi Digital Hydrometer on 12-03-2015 at 10:46 PM
I have always wondered about just putting a hydrometer in the primary (obviously talking about
a carboy here). Then I wouldn't have to touch it to find out the gravity. Only problem I see it
the CO2 b...