VIEW MY

Robg773

Gift Premium Subscription To Robg773

Join Date:

06-19-2012

Last Activity:

08-05-2015 10:07 AM

10 Likes on 8 Posts 

LATEST ACTIVITY

  • Posted in thread: Motorized Monster Mill Build MM3-2.0 on 07-07-2015 at 11:37 PM
    The side of the motor says for ccw wire this way and for cw swap these two wires.

  • Posted in thread: Motorized Monster Mill Build MM3-2.0 on 06-12-2015 at 09:02 PM
    That looks about right. I'll buy it. Thanks for pointing that out.

  • Posted in thread: Motorized Monster Mill Build MM3-2.0 on 06-12-2015 at 08:45 PM
    Good point. Did you do a torque caculation based on hp and rpm? Or a ratio based on
    relationship of hp and output torque?

  • Posted in thread: Motorized Monster Mill Build MM3-2.0 on 06-12-2015 at 08:28 PM
    Wish i could take credit for being that smart lol. The spec sheet for the 10:1 reducer lists an
    output soeed of 175rpm max and output torque of 515in-lb max.

  • Posted in thread: Motorized Monster Mill Build MM3-2.0 on 06-11-2015 at 11:22 PM
    1. I used two wood screws. There will prob never be any pressure on the switch housing so it
    prob will never move. 2. Very good question. I actually messed this up initially. The set screw
    won't grip ...

  • Posted in thread: New bulk grain buy, York, Harrisburg Lancaster Pa on 06-11-2015 at 01:45 AM
    I would like to join as well. Looking for 2-6 bags.

  • Posted in thread: Motorized Monster Mill Build on 06-02-2015 at 11:34 PM
    Take a pic of switch wiring pls.

  • Posted in thread: Motorized Monster Mill Build MM3-2.0 on 04-23-2015 at 11:38 PM
    Good idea stealthcruiser...the wiring isn't stiff so i didn't worry about chafing. Will do
    thanks.

  • Posted in thread: Motorized Monster Mill Build MM3-2.0 on 04-23-2015 at 04:33 PM
    Yes exactky why i went with a gear reducer. Cleaner look, safer, no rpm caculations. I got the
    gear reducer from surpluscenter.com if that helps any. With the reducer you're going to need
    couplers to ...

  • Posted in thread: Motorized Monster Mill Build MM3-2.0 on 04-23-2015 at 03:22 AM
    Nothing special here just tried to make wiring neat. Regarding the chute, its basically a
    shower floor liner ftom home depot cut and sandwiched between two pieces of wood then screwed
    into the undersi...

0 COMMENTS
POST A COMMENT

Newest Threads

LATEST SPONSOR DEALS