Last Activity:06-29-2015 2:30 AM
Likes Given: 3
1 Likes on 1 Posts
Posted in thread: Compressor Lock Up ? on 06-27-2015 at 04:17 PM
It has a small relay that it attached to compressor. 2 wires going in, none going out. the
compressor is starting but, shuts down after a few seconds
Posted in thread: Compressor Lock Up ? on 06-27-2015 at 03:59 PM
I've 119.1 volts going to relay. When relay clicks on, the compressor will come on, but then
goes into overload and shuts off after about 5 sec.I'm guessing it's most likely froze, I'm
going to slap i...
Posted in thread: Compressor Lock Up ? on 06-27-2015 at 03:28 PM
Have a whirlpool sidexside, controlled with STC1000. It has run fine for 2 years. I'm guessing
my compressor has locked up, the fan will start and compressor relay will click on but the
Posted in thread: Pid help!!! on 02-23-2015 at 03:16 AM
Give em a call. They are very helpful.Tech Support : 404-926-6098
Posted in thread: Adding DME To Washed Yeast Before Storing on 02-21-2015 at 03:53 AM
What I would like to do is to store enough yeast in a baby food jar to be able to pull it out
of cold storage and acclimate and add to fermenter.
Posted in thread: Adding DME To Washed Yeast Before Storing on 02-21-2015 at 02:30 AM
Once you have jarred your washed yeast, is there any reason you can't addDME and ferment out to
increase the yeast count before you put them to sleep?
Posted in thread: Variable resistance SSR for boil control? on 05-10-2014 at 02:21 AM
price and reliable.From Auberins, they ship from Georgia. I usually have my stuff in 3 or 4
days.Their heatsinks are pricey, I would source them elsewhere if you want them cheaper.
Posted in thread: POR-15 to prevent rust on camco heating elements? on 03-30-2014 at 05:19 AM
I would rather let em rust . They should develop a layer of surface rust which will protect the
metal from further rusting. That's what I 'm hoping will happen to mine. These elements were
Posted in thread: Ranco terminal screws on 03-27-2014 at 01:35 AM
I have never seen a terminal strip with left hand threads. Should be clockwise to tighten.
Posted in thread: Ranco terminal screws on 03-27-2014 at 01:19 AM
Have you tried turning both ways ? Are they frozen tight or loose ?