VIEW MY

reynolds5520

Gift Premium Subscription To reynolds5520

Join Date:

01-05-2010

Last Activity:

07-28-2014 12:31 PM

Likes Given: 14

33 Likes on 26 Posts 

    ABOUT ME

  • Western Fingerlakes NY
  • Kevin
  • Mac & Jacks Clone
  • Male
  • Married

LATEST ACTIVITY

  • Posted in thread: Help wiring 240v motor for grain mill on 07-28-2014 at 04:34 PM
    Here is what i plan to try tonight. This should match the original schematic.Yes, start
    there.FWIW, there is no neutral conductor in this single phase 240V configuration. The two
    conductors are more a...

  • Posted in thread: Help wiring 240v motor for grain mill on 07-28-2014 at 02:39 AM
    Connecting power to M4 will just bypass the protector.Have you done a test of the motor without
    the switch? You should be able to connect hot to M1, and neutral to M2 and have it run. Then
    disconnect ...

  • Posted in thread: Help wiring 240v motor for grain mill on 07-27-2014 at 07:54 PM
    Looking at your drawing again, Neutral on S6 is effectively the same circuit as what I
    described. It just interrupts both hot and neutral when the switch is in the center off
    position.

  • Posted in thread: Help wiring 240v motor for grain mill on 07-27-2014 at 07:47 PM
    Looks like you have it almost correct in the drawing. The neutral connects to M2. Nothing on
    S6.The connection at the mid point of the coils has to do with the way this motor is configured
    for use on ...

  • Posted in thread: Grain mill shaft and lovejoy couplings on 07-26-2014 at 02:09 AM
    Mcmaster Carr shows Iron Hubs with keyway and set screw in 1/2" and 20mm for the 1 3/4 inch
    O.D. spiders.

  • Posted in thread: Help wiring 240v motor for grain mill on 07-25-2014 at 04:41 PM
    To expand a bit...If you decide to go with a separate master power switch before the motor,
    then you need to be sure to turn it off before changing the direction with the drum switch. To
    eliminate the...

  • Posted in thread: Help wiring 240v motor for grain mill on 07-25-2014 at 04:07 PM
    I don't think you can safely do it with that drum switch alone. That switch could be used to
    swap J10 and T8 but it can't also interrupt the power to M1 and M2 (or even just the power on
    M1.)One solut...

  • Posted in thread: FastRack Party Pack Giveaway! - Open to All Members! on 07-22-2014 at 05:10 PM
    in

  • Posted in thread: Ultra Barrier Silver Beer Hose Giveaway from Kegconnection.com! on 07-22-2014 at 02:25 AM
    in

  • Posted in thread: Glycol Chiller Build Help...wiring? on 07-15-2014 at 05:19 PM
    If it will power up in the run mode, you can try just having the STC turn the whole thing on
    and off. So long as the AC unit is set for a temp below your room temp, and the sensor of the
    unit is in th...

0 COMMENTS
POST A COMMENT