Last Activity:07-13-2016 12:45 AM
3 Likes on 2 Posts
Posted in thread: Water pouring out of freezer lid?!?!?!? on 05-19-2016 at 10:38 AM
Maybe 3 years old. Maybe 2. Not very old at all.
Posted in thread: Water pouring out of freezer lid?!?!?!? on 05-19-2016 at 12:44 AM
So, I defrosted the freezer that I plan to eventually use as a keezer and opened the drain to
let it drain out. The next day, I opened the lid to see if it was done and water poured out of
the edge of...
Posted in thread: Show us your panel on 01-22-2016 at 12:32 AM
You guys with the key switches crack me the $^#* up... Do you take the key and hide it when
you're not "at the helm" of your brewery, like when you run to the can?My panel is under
construction. So I ...
Posted in thread: Pex vs copper vs silicone on 01-07-2016 at 03:38 AM
A friend of mine has the crimper for pex, so I would be using the cheap pex barbs. No
Posted in thread: Pex vs copper vs silicone on 01-07-2016 at 01:59 AM
So, I am building my electric brewery. For my HLT, I don't bet really plan to move it. It will
be on an upper tier. I was thinking of either running PEX or copper to it, since it is only
ever going to...
Posted in thread: DS18B20 vs RTD on 01-05-2016 at 01:17 PM
I bought a bunch of small thermo wells that would barely fit bare RTD sensors (that I already
own) or the DS sensors. I already plan on doing a board layout for a bunch of my other circuits
I need. So...
Posted in thread: DS18B20 vs RTD on 01-05-2016 at 11:56 AM
So, I plan to use an Arduino, but I already have a schematic for implementing an RTD circuit. I
guess the question is, is it worth the added effort?
Posted in thread: DS18B20 vs RTD on 01-05-2016 at 01:46 AM
I am building an electric brewery and can build an RTD circuit or use a ds18b20 type sensor.
What does everyone suggest? Do I really need the better option? My KISS, low budget, it's good
Posted in thread: 60 amp gfci to sub-panel question on 12-22-2015 at 06:27 PM
Thanks everyone for your help.
Posted in thread: 60 amp gfci to sub-panel question on 12-22-2015 at 06:26 PM
Ok, so even if my two hots are loaded unequally everything will be fine as long as my neutral
goes through the gfci and my ground does not. My neutral and ground are only bonded at the main