Last Activity:01-14-2017 10:45 PM
Likes Given: 210
49 Likes on 44 Posts
Posted in thread: First time brew with RO water on 01-13-2017 at 11:05 PM
I joined in your thread about treating your RO brewing water. To make predicting brewing water
pH, and other water qualities, easier to understand I suggest you try ezBrewingWater-ROŠI use
it all the ...
Posted in thread: First time brew with RO water on 01-13-2017 at 10:34 PM
LibreOffice is a free and open source office suite, roughly equivalent to MS Office that should
open Bru'n water fine.You can download it at
Posted in thread: First time brew with RO water on 01-13-2017 at 08:41 PM
Pre Boil Volume is 13.5 Gallons... As my new fermenter has a 1.5G dead space in it, and I am
trying to end up with 11 Gallons into the kegs, I am shooting for a 12.5 Gallon batch.. Too big
to mash it ...
Posted in thread: First time brew with RO water on 01-13-2017 at 07:58 PM
That is dependent on mash volume, grain bill and any salts you plan to add to your mash if
targeting a water profile. Utilizing Brun Water should make the estimate easy to get in the
ballpark of your ...
Posted in thread: First time brew with RO water on 01-13-2017 at 07:57 PM
Okay, thanks...I'm gonna post the entire recipe in a bit and my calculations for how much water
I need, and try asking again.....Gonna crush the grains tonight and make the water tonight, for
Posted in thread: First time brew with RO water on 01-13-2017 at 07:12 PM
Gonna be doing my second batch on the new system tomorrow... Had to make some upgrades and
changes before I was ready to try again...Anyways, I picked up some lactic acid to use instead
of the acidula...
Posted in thread: Measuring Dissolved Oxygen.... on 01-13-2017 at 07:06 PM
Will be using oxygen (in line at the fermenter) for the first time tomorrow...I'm at 4200'
elevation.. How long do I inject oxygen into the wort for 12.5 gallons into the fermenter?
Posted in thread: Putting together an O2 system... question on 11-27-2016 at 07:16 PM
Your setup is similar to mine.. I recently bought a oxygen flow meter to put inline.The reason
I went with the inline and stopped using the wand was the fact that the wand only oxygenates
the wort in ...
Posted in thread: Beginning my EBIAB Brewery Build.. on 11-26-2016 at 11:06 PM
Here it is all hooked up... The 1/2" line that is used to pump the finished wort from the
brewery to the fermenter will be hooked up to the cam lock connector on the other (left side in
the above pict...
Posted in thread: Beginning my EBIAB Brewery Build.. on 11-26-2016 at 11:05 PM
So, the 1" Tee, and the (3) 1" x 1/2" reducers finally arrived yesterday, and I put my new in
line oxygenation system together... (shown in disconnected ready to store mode)